Investigating the oxidative synthesis of copper oxide nanowires: Wettability and photoelectrochemical insights

Siddharth Rana,Jyoti Yadav,Sneha Senapati,Ray-Hua Horng,J.P. Singh
DOI: https://doi.org/10.1016/j.apmt.2024.102485
IF: 8.663
2024-10-24
Applied Materials Today
Abstract:In this report, we fabricated the copper oxide nanowires by thermally oxidizing copper foil in different ambient environments such as: air, argon, and oxygen. The as-synthesized samples showed very low reflectance properties, and the contact angle measurements revealed a wide range of contact angles, ranging from 32.6° to 101.6°. The difference in the wettability behavior was attributed to the varying proportions of cupric and cuprous oxide in the growth process, as well as the existence of oxygen vacancies. The presence of the adsorbed hydroxyl groups on the surface was found to greatly influence the hydrophilicity of the surface. Furthermore, the synthesized samples were tested as photoelectrochemical water-splitting electrodes to assess their performance. The photocurrent density of samples synthesized in air, argon, and oxygen was 1.02, 1.4, and 1.8 mA/cm 2 , respectively The results showed that samples synthesized in an oxygen environment showed a lower charge transfer resistance at the electrode-electrolyte interface with the highest shift in flat band potential. The study demonstrates a cost-effective method to modify wetting properties and enhance the photoelectrochemical performance of the copper foil.
materials science, multidisciplinary
What problem does this paper attempt to address?