Abstract:In bridge structure monitoring and evaluation, deformation data serve as a crucial basis for assessing structural conditions. Different from discrete monitoring points, spatially continuous deformation modes provide a comprehensive understanding of deformation and potential information. Terrestrial laser scanning (TLS) is a three-dimensional deformation monitoring technique that has gained wide attention in recent years, demonstrating its potential in capturing structural deformation models. In this study, a TLS-based bridge deformation mode monitoring method is proposed, and a deformation mode calculation method combining sliding windows and surface fitting is developed, which is called the SWSF method for short. On the basis of the general characteristics of bridge structures, a deformation error model is established for the SWSF method, with a detailed quantitative analysis of each error component. The analysis results show that the deformation monitoring error of the SWSF method consists of four parts, which are related to the selection of the fitting function, the density of point clouds, the noise of point clouds, and the registration accuracy of point clouds. The error caused by point cloud noise is the main error component. Under the condition that the noise level of point clouds is determined, the calculation error of the SWSF method can be significantly reduced by increasing the number of points of point clouds in the sliding window. Then, deformation testing experiments were conducted under different measurement distances, proving that the proposed SWSF method can achieve a deformation monitoring accuracy of up to 0.1 mm. Finally, the proposed deformation mode monitoring method based on TLS and SWSF was tested on a railway bridge with a span of 65 m. The test results showed that in comparison with the commonly used total station method, the proposed method does not require any preset reflective markers, thereby improving the deformation monitoring accuracy from millimeter level to submillimeter level and transforming the discrete measurement point data form into spatially continuous deformation modes. Overall, this study introduces a new method for accurate deformation monitoring of bridges, demonstrating the significant potential for its application in health monitoring and damage diagnosis of bridge structures.

A Morphology Filter-Assisted Extreme-Point Symmetric Mode Decomposition (MF-ESMD) Denoising Method for Bridge Dynamic Deflection Based on Ground-Based Microwave Interferometry

Dynamic Monitoring and Data Analysis of a Long-Span Arch Bridge Based on High-Rate GNSS-RTK Measurement Combining CF-CEEMD Method

FE-based Bridge Weigh-in-motion Based on an Adaptive Augmented Kalman Filter

Simultaneous de-noising and enhancement method for long-span bridge health monitoring data based on empirical mode decomposition and fractal conservation law

Wavelet De-Noising with Improved Threshold Method for Bridge Health Monitoring

Application of Morphology Filtering Method in Vibration Signal De-Noising

Research of de-noising method of bridge strain signal based on empirical mode decomposition method

Displacement Monitoring of a Bridge Based on BDS Measurement by CEEMDAN-Adaptive Threshold Wavelet Method

Dynamic displacement estimation and modal analysis of long-span bridges integrating multi-GNSS and acceleration measurements

An Integrated Machine Learning Algorithm for Separating the Long-Term Deflection Data of Prestressed Concrete Bridges

Measurement of Long-Term Periodic and Dynamic Deflection of the Long-Span Railway Bridge Using Microwave Interferometry

Kalman Filter Based Estimation of Neutral Axis Position of Bridge Deck under Traffic Loading

Temperature-induced deflection separation based on bridge deflection data using the TVFEMD-PE-KLD method

Dynamic Deformation Measurement of Bridge Structure Based on GB-MIMO Radar

Drive-by bridge damage detection using Mel-frequency cepstral coefficients and support vector machine

High-Precision Monitoring Method for Bridge Deformation Measurement and Error analysis Based on Terrestrial Laser Scanning

A remote deflection detection method for long-span bridges using adaptive mask and high-resolution camera

Nonlinear and Nonstationary Detection and Quantification of Multi-Scale Measured Signals for Bridge Structure

Bridge Deflection Measurement Using Wireless Mems Inclination Sensor Systems

Automatic uncoupling of massive dynamic strains induced by vehicle- and temperature-loads for monitoring of operating bridges

An Improved Second-Order Blind Identification (SOBI) Signal De-Noising Method for Dynamic Deflection Measurements of Bridges Using Ground-Based Synthetic Aperture Radar (GBSAR)