Abstract:We report on the difficulties of extracting plastic parameters from constitutive equations derived by instrumented indentation tests on hard and stiff materials at shallow depths of penetration. As a general rule, we refer here to materials with an elastic stiffness more than 10 % of that of the indenter and a yield strain higher than 1 %, as well as to penetration depths less than ∼ 5 times the characteristic tip defect length of the indenter. We experimentally tested such a material (an amorphous alloy) by nanoindentation. To describe the mechanical response of the test, namely the force-displacement curve, it is necessary to consider the combined effects of indenter tip imperfections and indenter deformability. For this purpose, an identification procedure has been carried out by performing numerical simulations (using Finite Element Analysis) with constitutive equations that are known to satisfactorily describe the behaviour of the tested material. We propose a straightforward procedure to address indenter tip imperfection and deformability, which consists of firstly taking account of a deformable indenter in the numerical simulations. This procedure also involves modifying the experimental curve by considering a truncated length to create artificially the material’s response to a perfectly sharp indentation. The truncated length is determined directly from the loading part of the force-displacement curve. We also show that ignoring one or both of these issues results in large errors in the plastic parameters extracted from the data.

Crystal plasticity assessment of the effect of material parameters on contact depth during spherical indentation

Investigation of fatigue mechanical properties of apolycrystalline solid at mesoscopic scale using depth-sensing indentation (DSI) technique

Identification of plastic properties through spherical indentation

Numerical and Experimental Studies of Deep Indentation on Single Crystals

Investigation of the Evolution of Plastic Anisotropy and Pile-up of Al Single Crystal in Nanoindentation Using Different Crystal Plasticity Models

Indentation Size Effect: a Study Via the Mechanism-based Strain-Gradient Plasticity Theory

The Effect of Indenter Angle on the Microindentation Hardness

Spherical Indentation into Elastoplastic Materials: Indentation-response Based Definitions of the Representative Strain

Computational Simulations of Micro-Indentation Tests Using Gradient Plasticity

The Influence of Indenter Tip Imperfection and Deformability on Analysing Instrumented Indentation Tests at Shallow Depths of Penetration on Stiff and Hard Materials

On the crystallographic anisotropy of plastic zone size in single crystalline copper under Berkovich nanoindentation

Determining plastic properties of a material with residual stress by using conical indentation

MACRO- AND MICROSCOPIC APPROACHES TO PLANE STRAIN DEFORMATION STATES OF FACE-CENTERED CUBIC METALS UNDER WEDGE INDENTATION

Video Enhanced Depth-Sensing Indentation Technique for Characterizing Mechanical Behaviour of Biomaterials

Experimental and numerical investigations of anisotropic plasticity response in polycrystalline copper by nanoindentation

Inverse Method to Determine Parameters for Time-Dependent and Cyclic Plastic Material Behavior from Instrumented Indentation Tests

Computer experiments on nano-indentation: A molecular dynamics approach to the elasto-plastic contact of metal copper

Unveiling orientation dependence of anisotropic plasticity in polycrystalline copper by nanoindentation

A study of microindentation hardness tests by mechanism-based strain gradient plasticity

Friction Effect on Micro-indentation Measurement with Different Indenters