Abstract:Using molecular dynamics (MD) simulations, the defect evolution and plastic deformation mechanism of single-crystalline and polycrystalline copper under spherical nanoindentation are investigated and compared with previous nanoindentation simulations and experiments. To reveal the grain size effects on the indentation-induced internal stress and deformation behavior, the polycrystalline copper with different grain size are adopted in nanoindentation simulations, whose grain size are follow the inverse Hall-Perch relation. To study the grain boundary network effect, the grain boundary interface is further divided into three microstructural components with different dimensions. The results show that the indentation force of single-crystalline copper is larger than that of polycrystalline copper, and that of polycrystalline copper continuously decreases with the decrease of grain size due to softening phenomenon. The defect nucleation and propagation region in both single-crystalline and polycrystalline copper appear below the tool tip, due to the high internal stress and atomic potential energy induced by nanoindentation. The horizontal propagation of defects is faster and larger than the vertical propagation of that, and such defects are limited in the grains around the tool tip due to grain boundary network. An obvious stresses and potential energy gradient exist under tool tip in single-crystalline copper, and such gradients are possibly distributed along multiply direction in the polycrystalline copper. The internal stresses and atomic potential energy in the region of VP are highest, followed by that in TJ, GB and VP, resulting in the defect nucleation and propagation are more possible occur in VP than other microstructural components.

Experimental and numerical investigations of anisotropic plasticity response in polycrystalline copper by nanoindentation

Unveiling orientation dependence of anisotropic plasticity in polycrystalline copper by nanoindentation

Modeling the Strain Rate-Dependent Constitutive Behavior in Nanotwinned Polycrystalline Metals

On the crystallographic anisotropy of plastic zone size in single crystalline copper under Berkovich nanoindentation

High Strain Gradient Plasticity Associated with Wedge Indentation into Face-Centered Cubic Single Crystals: Geometrically Necessary Dislocation Densities

The Influence of Crystallographic Orientation and Grain Boundary on Nanoindentation Behavior of Inconel 718 Superalloy Based on Crystal Plasticity Theory

Crystalline Plasticity On Copper (001), (110), And (111) Surfaces During Nanoindentation

Numerical and Experimental Studies of Deep Indentation on Single Crystals

Investigation of the Evolution of Plastic Anisotropy and Pile-up of Al Single Crystal in Nanoindentation Using Different Crystal Plasticity Models

Orientation-dependent plastic flow in nanoscratching of copper surfaces

MACRO- AND MICROSCOPIC APPROACHES TO PLANE STRAIN DEFORMATION STATES OF FACE-CENTERED CUBIC METALS UNDER WEDGE INDENTATION

Effect of Initial Indentation Position on Plastic Deformation Behaviors of Polycrystalline Materials Via Molecular Dynamics Simulation

An investigation of the combined size and rate effects on the mechanical responses of FCC metals

Molecular dynamics simulation on mechanisms of plastic anisotropy in nanotwinned polycrystalline copper with {111} texture during tensile deformation

Investigation of Grain Boundary and Orientation Effects in Polycrystalline Metals by a Dislocation-Based Crystal Plasticity Model

Plastic Anisotropy and Associated Deformation Mechanisms in Nanotwinned Metals

Grain Size Effects on Indentation-Induced Defect Evolution and Plastic Deformation Mechanism of Ploycrystalline Materials

Bending, Nanoindentation and Plasticity Noise in FCC single and poly crystals

Pramatic Atomistic Analysis of Nano-scale Metal Plasticity

Developing Multi-Scale Model to Study Atypical Crystal Plastic Behavior

Effects of crystallographic orientations and grain boundaries on nanoscratching behaviour of unique bi-crystal Cu