Abstract:Discontinuities in cast products, obtained from a liquid state of an alloy, are the result of phenomena occurring during multiphase system crystallization. On the one hand, compacted defects as a shrinkage pipe are relatively easy to eliminate. On the other hand, it is known that presence of fine shrinkage and gas porosity is unavoidable. Detectability of these dispersed discontinuities depends on type of inspection method applied. Structure, including intensity and location of porosity zones, is dependent on the type of the alloy, casting configuration and conception of technological solution, related with control of velocity of the heat extraction to the mould. Thus, mechanical properties in the volume of a casting are not homogenous and are strongly reduced only in the zones of porosity. However, in strength calculations of cast products, this obvious fact is not taken into consideration. The rule of material homogeneity is applied instead, along with drastic increase of factor of safety. The paper indicates benefits of precise determination of limits of porosity zones located in the casting, using the NTD methods (for example, Phased Array ultrasonic tomography). Coordinates of porosity zones in 3D, introduced into CAD geometry and assigned with different properties allow to estimate the actual state of stress and strain of real object using FEM methods (systems like Ansys, Comsol). Load justified by operating conditions and application of tolerance of damage rule, with simultaneous reference to the limited state of stress according to LOV (Loss of Volume) and LEFM (Linear Elastic Fracture Mechanics) methods should find their place in design procedures of cast products, which will allow for better use of material and reduction of weight of the casting. This approach, named Tolerance of damage concerning the castings is the motto of this paper.

Internal Porosity Defects in Ductile Cast Irons

Procedure of Eliminating Porosity in Grey Cast Iron with Low Sulphur Content

Problem of Acceptability of Internal Porosity in Semi-Finished Cast Product as New Trend "Tolerance of Damage" Present in Modern Design Office

Reproduction of fissure corrosion and mechanism for fissure formation on ductile cast iron

Investigation on Surface Defects Produced in Pretreatment of Die-casting AM60B Magnesium Alloy

Identifying Critical Defect Sizes From Pore Clusters in Nickel-based Superalloys Using Automated Analysis and Casting Simulation

Macro Porosity Prediction of Sg Iron Castings Considering Microstructure Formation

Formation mechanism and control of a kind of pit-shaped defect in Cf53 rolled products

On the Competition between Pores and Hidden Entrainment Damage during In Situ Tensile Testing of Cast Aluminum Alloy Components

Casting defects and microstructure distribution characteristics of aluminum alloy cylinder head with complex structure

On the Porosity Induced by Externally Solidified Crystals in High-Pressure Die-Cast of Am60b Alloy and Its Effect on Crack Initiation and Propagation

Relationship Between Porosity Distribution and Mechanical Properties of Vacuum Die Casting AM50 Magnesium Alloy

Influence of aluminium on the formation of pinholes in cast irons

PREDICTION OF SHRINKAGE CAVITY AND POROSITY IN GRAY CAST IRON DURING SOLIDIFICATION

Analysis of Formation Mechanism of Typical Defects in Aluminum (Magnesium) Alloys Castings by the Expendable Pattern Shell Casting with Vacuum and Low Pressure

PM and Rheocasting in Ductile Iron Castings

Prediction of intrusive gas pores caused by resin burning in sand core for iron castings

Effects of Process Parameters on Shrinkage Porosity in 357 Semi-Solid Die Casting Parts

Microstructure Feature of Friction Stir Processed Ductile Cast Iron

Numerical simulation of shrinkage porosity defect in billet continuous casting

Iron-rich intermetallic phases and their role in casting defect formation in hypoeutectic Al-Si alloys