Abstract:In sand casting, gas porosity is a common defect that can result in decreased strength, leakage, rough surfaces, or other problems. Although the forming mechanism is very complicated, gas release from sand cores is often a significant contributor to the formation of gas porosity defects. Therefore, studying the gas release behavior of sand cores is crucial to solving this problem. Current research on the gas release behavior of sand cores mainly focuses on parameters such as gas permeability and gas generation properties, through experimental measurement and numerical simulation methods. However, accurately reflecting the gas generation situation in the actual casting process is difficult, and there are certain limitations. To achieve the actual casting condition, a sand core was designed and enclosed inside a casting. The core print was extended to the sand mold surface, with two types of core prints: hollow and dense. Pressure and airflow speed sensors were installed on the exposed surface of the core print to investigate the burn-off of the binder of the 3D-printed furan resin quartz sand cores. The experimental results showed that the gas generation rate was high in the initial stage of the burn-off process. The gas pressure quickly reached its peak in the initial stage and then decreased rapidly. The exhaust speed of the dense type of core print was 1 m/s, lasting for 500 s. The pressure peak of the hollow-type sand core was 1.09 kPa, and the exhaust speed peak was 1.89 m/s. The binder can be sufficiently burned off for the location surrounding the casting and the crack-affected area, so the burnt sand appears white, while the burnt core appears black due to insufficient burning of the binder because of isolation from the air. The gas generated by the burnt resin sand in contact with air was 30.7% less than that generated by the burnt resin sand insulated from the air.

Prediction of intrusive gas pores caused by resin burning in sand core for iron castings

Research on Gas Pore Prediction Method Based on Sand Core Characteristic Time

Study on the Gas Release of 3D-Printed Furan Resin Sand Core During the Casting Process

Numerical research of gas-related defects for gray cast iron during sand casting

Macro Porosity Prediction of Sg Iron Castings Considering Microstructure Formation

Numerical Simulation of Air Entrapment Phenomenon During Mold Filling of High Pressure Die Casting Process

Numerical simulation of flow-induced air entrapment defects in the high pressure die casting process

Prediction method of shrinkage cavity and shrinkage porosity in solidification process under low-pressure casting

Internal Porosity Defects in Ductile Cast Irons

Mathematical Modeling of Transient Submerged Entry Nozzle Clogging and Its Effect on Flow Field, Bubble Distribution and Interface Fluctuation in Slab Continuous Casting Mold

An Innovative Production Prediction Model for Fractured Horizontal Wells in Low‐Permeability Gas Reservoirs Accounting for Proppant Embedment

Analytical prediction of keyhole porosity in laser powder bed fusion

Multiphase and multiphysics modeling of dendrite growth and gas porosity evolution during solidification

Numerical Simulation of Casting Filling Process of Composites Reinforced with Nano SiC Based on Smoothed Particle Hydrodynamics

Direct Observation of Filling Process and Porosity Prediction in High Pressure Die Casting

Flow Dynamic Analysis of Core Shooting Process Through Experiment and Multiphase Modeling

Numerical simulation and optimization of liquid metal flow in the shot sleeve of cold chamber die casting process

Modeling and Simulation of the Casting Process with Skeletal Sand Mold

Computer-Aided Engineering (CAE) Simulation for the Robust Gating System Design: Improved Process for Investment Casting Defects of 316L Stainless Steel Valve Housing

Numerical Analysis of Slag–Steel–Air Four-Phase Flow in Steel Continuous Casting Model Using CFD-DBM-VOF Model

One-dimensional predictive model for estimation of interfacial heat transfer coefficient during solidification of cast iron in sand mould