Abstract:To improve the casting quality as well as the casting efficiency during the casting process, the effect of the interaction of process parameters and system structural parameters on the shrinkage volume and efficiency of the casting was investigated in this paper by using the response surface method for the simulation prediction of A356 alloy sand casting. The relationship between variables and response (shrinkage volume, solidification time) was established by Box-Behnken Design with pouring temperature (650–710 °C), mold preheating temperature (200–300 °C), width/thickness ratio of cross-section of sprue (1.2–1.5), width/thickness ratio of inner sprue section (2–4) and length/diameter ratio of straight sprue (1.5–2.5) as variables by the response surface method. The results are then optimized, and the optimal solution is selected by the NSGA-II algorithm and TOPSIS method. The results show that the changes in the cavities of the optimized and improved pouring system enhance the flow of the metal fluid and make the filling more complete. The gentle cooling of temperature is conducive to heat dissipation and layer-by-layer sequential solidification, which can effectively eliminate the casting's internal shrinkage loosening and shrinkage holes defects, thus forming a dense casting with good performance. After solving the optimized parameters and improving the pouring system, the solidification time (integrated solidification time) was reduced from 129.24 to 88.10s, and the shrinkage volume was reduced from 9.68 to 4.06 cm 3 .

Prediction method of shrinkage cavity and shrinkage porosity in solidification process under low-pressure casting

Process Optimization of Low-pressure Die Casting of Aluminum Alloy Wheel based on Taguchi Method

Die Structure Optimization of Aluminum Alloy Wheel Low-Pressure Die Casting Based on CAE

Study on Numerical Simulation of Mold Filling and Solidification Processes under Pressure Conditions

Optimization of low-pressure die casting process parameters for reduction of shrinkage porosity in ZL205A alloy casting using Taguchi method

Low pressure casting technology and forming process analysis of metal mold based on ProCAST FEA procedure

Criteria for Prediction of Shrinkage Cavities and Porosity in Castings

Determination of casting parameters of thick wall die-casting of magnesium alloy and simulation of its processing

Optimization of Casting System Structure Based on Genetic Algorithm for A356 Casting Quality Prediction

Solidification simulation of automobile wheel in low pressure casting

A Mathematical Model for Simulating the Microporosity of Squeeze Casting of Aluminum Alloy

Studies on formation of shrinkage cavity and porosity of steel castings by taking filling process into account

Numerical Simulation and Optimization of Indirect Squeeze Casting Process

Shrinkage porosity prediction empowered by physics-based and data-driven hybrid models

Study of Mold Filling Simulation on Low Pressure Die Casting for Automobile Wheel Casting

Optimization of vacuum counter-pressure casting process for an aluminum alloy casing using numerical simulation and defect recognition techniques

Key Analysis of Design and Numerical Simulation for Aluminum Alloy Impeller Low-pressure Casting Mold

Numerical simulation of shrinkage porosity defect in billet continuous casting

Study and Application of Mold Filling Simulation of Shaped Castings

Study on numerical simulation of mold-filling and solidification processes of shaped casting

A New Method for Quickly Locating the Hot Spots in Solidification Simulation of Complicated Castings