Abstract:The most common defect found in the high pressure die casting(HPDC) process is gas porosity which significantly affects the mechanical properties of the final components.As it is known,the air entrapment of the liquid metal flow during the mold filling stage has a close relationship with the gas porosity distribution in die castings.The generation of the entrapped air is mainly due to the interaction between air and liquid metal in the die cavity.In the past few decades,extensive efforts have been made to develop numerical models for the simulation of mold filling.However,these efforts mainly focused on the single phase flow models which can only predict the liquid metal flow and assume that the effect of air in the die cavity is negligible.As a result, these models could not provide the quantity and location of entrapped air in die castings.Recently, several research results on tracking the entrapped air in the molten metal flow have been reported but some techniques still need to be improved further and much more researches are required.In this study,a liquid-gas coupled model is presented to simulate the air entrapment phenomenon during the HPDC mold filling process.The pressure of the entrapped air bubbles is solved at each time step. The calculations of the liquid and gas phases are combined together through the pressure transfer.In order to verify the validity and stability of this model,a specially designed water analog experiment was carried out and compared with the numerical simulation results of the liquid-gas coupled model and the single phase flow model,respectively.The comparison shows that the liquid-gas coupled model has better prediction accuracy than the single phase flow model in tracking the entrapped air bubbles.

Numerical Simulation of Air Entrapment Phenomenon During Mold Filling of High Pressure Die Casting Process

Numerical simulation of flow-induced air entrapment defects in the high pressure die casting process

Numerical simulation of filling flow of polymer melt in injection molding

Numerical Simulation of Die-Casting Mold Filling Process Based on Fractional Step Method

An Improved Mathematical Model to Simulate Mold Filling Process in High Pressure Die Casting Using CLSVOF Method and CSF Model

Study on Numerical Simulation of Mold Filling and Solidification Processes under Pressure Conditions

Direct Observation of Filling Process and Porosity Prediction in High Pressure Die Casting

Research Progress on Modeling and Simulation of Air and Oxide Film Entrapment During Mold Filling of Aluminum Casting

Numerical simulation and optimization of liquid metal flow in the shot sleeve of cold chamber die casting process

Numerical Simulation of Casting Filling Process of Composites Reinforced with Nano SiC Based on Smoothed Particle Hydrodynamics

Numerical Simulation of Fluid Flow and Heat Transfer During Mold Filling for Die Casting

The Numerical Simulation of Flow Field of the Slow Shot Phase in the Shot Sleeve

Study on Numerical Simulation of Mold Filling and Heat Transfer in Die Casting Process

WATER MODELING OF MOULD FILLING DURING SUCTION CASTING PROCESS OF AUTOMOTIVE EXHAUST VALVES OF Γ-Tial BASED ALLOYS

Study and Application of Mold Filling Simulation of Shaped Castings

Water Analogue Validation of Numerical Model for Fluid Flow During Slow Shot Phase in Die Casting Process

Numerical Simulation of Multiphase Flow in Steel Continuous Casting Mold Using a Novel Euler–Euler–Lagrange Method

Finite element analysis for die casting parameters in high-pressure die casting process

Study on the Critical Mould Entry Velocities of Thin-wall Castings by Numerical Simulation

Dynamic Model of Mold Filling Process under Low Pressure Casting

Numerical Simulation of Mold Filling During Centrifugal Casting of TiAl Alloy Exhaust Valve