Abstract:The most common defect found in the high pressure die casting(HPDC) process is gas porosity which significantly affects the mechanical properties of the final components.As it is known,the air entrapment of the liquid metal flow during the mold filling stage has a close relationship with the gas porosity distribution in die castings.The generation of the entrapped air is mainly due to the interaction between air and liquid metal in the die cavity.In the past few decades,extensive efforts have been made to develop numerical models for the simulation of mold filling.However,these efforts mainly focused on the single phase flow models which can only predict the liquid metal flow and assume that the effect of air in the die cavity is negligible.As a result, these models could not provide the quantity and location of entrapped air in die castings.Recently, several research results on tracking the entrapped air in the molten metal flow have been reported but some techniques still need to be improved further and much more researches are required.In this study,a liquid-gas coupled model is presented to simulate the air entrapment phenomenon during the HPDC mold filling process.The pressure of the entrapped air bubbles is solved at each time step. The calculations of the liquid and gas phases are combined together through the pressure transfer.In order to verify the validity and stability of this model,a specially designed water analog experiment was carried out and compared with the numerical simulation results of the liquid-gas coupled model and the single phase flow model,respectively.The comparison shows that the liquid-gas coupled model has better prediction accuracy than the single phase flow model in tracking the entrapped air bubbles.

Research Progress on Modeling and Simulation of Air and Oxide Film Entrapment During Mold Filling of Aluminum Casting

Numerical Simulation of Air Entrapment Phenomenon During Mold Filling of High Pressure Die Casting Process

Study on the Critical Mould Entry Velocities of Thin-wall Castings by Numerical Simulation

WATER MODELING OF MOULD FILLING DURING SUCTION CASTING PROCESS OF AUTOMOTIVE EXHAUST VALVES OF Γ-Tial BASED ALLOYS

Numerical simulation of flow-induced air entrapment defects in the high pressure die casting process

Study on Macro- and Micromodeling of the Solidification Process of Aluminum Shape Casting

Study on numerical simulation of mold-filling and solidification processes of shaped casting

Study and Application of Mold Filling Simulation of Shaped Castings

An Improved Mathematical Model to Simulate Mold Filling Process in High Pressure Die Casting Using CLSVOF Method and CSF Model

A Mathematical Model for Simulating the Microporosity of Squeeze Casting of Aluminum Alloy

Research on the Forming Mechanism of Micro/Nano Features During the Cast Molding Process

Characteristics of Mold Filling and Entrainment of Oxide Film in Low Pressure Casting of A356 Alloy

Progress on Numerical Simulation of Mold Filling and Solidification Processes of Shaped Castings

Study on Numerical Simulation of Mold Filling and Solidification Processes under Pressure Conditions

Simulation Analysis on Micro Hole Forming of Aluminum Alloy in Extrusion Casting Process

Modeling of filling and solidification process for TiAl exhaust valves during suction casting

Low pressure casting technology and forming process analysis of metal mold based on ProCAST FEA procedure

The Challenge and Progress in Macro- and Micro-modeling and Simulation of Squeeze Casting Process

Modeling of microporosity evolution and fatigue life of aluminum alloy castings

Study on Numerical Simulation of Mold Filling and Heat Transfer in Die Casting Process

Research On Macro And Micro Modeling Of Solidification Process Of Shaped Casting