Abstract:Automobile steering knuckle is an important part of the steering system, which is subjected to significant impacts and loads during its operation. Generally, cast aluminum steering knuckles are usually produced using some type of enhanced low-pressure casting process, like counter-pressure casting. Compared with aluminum forging and sand cast ductile iron, it can improve the production speed and achieve the adequate casting quality. In this study, various methodologies such as dynamic thermomechanical analysis, differential scanning calorimetry, and the laser flash method were employed to study the thermophysical properties of AlSi7Mg0.3. Further, the physical model of a counter-pressure casting system with an aluminum interior was established based on the combination of the tested and the theoretical properties of aluminum; this was achieved with the consideration of the presence of other factors including rapid solidification. The temperature field of the system was computed and verified by thermocouples at six different points during the tooling and the shrinkage simulation. It was observed that the plot shape of the computed temperatures and that of the simulated ones correlated; further, the difference between the peaks and the valleys was controlled to be 3% on an average, with the maximum variation of 7% at only one point. Moreover, all the predicted shrinkages were verified by the casting. This study provides a solid foundation for facilitating the simulation of the morphologies of the microstructure.

Simulation Analysis on Micro Hole Forming of Aluminum Alloy in Extrusion Casting Process

Study on Simulation of Stamping Forming and Die Surface Optimization of Aluminum Alloy Plate

Simulation Analysis of Thermal Stress During Casting Process of Large-Sized Alloy Steel Ingot

Die Structure Optimization of Aluminum Alloy Wheel Low-Pressure Die Casting Based on CAE

Simulation of High-Speed Milling Process of Aerospace Aluminum Alloy

A Mathematical Model for Simulating the Microporosity of Squeeze Casting of Aluminum Alloy

Numerical Simulation and Experimental Investigation of Microstructure Evolution and Flow Behavior in the Rheological Squeeze Casting Process of A356 Alloy

Microstructure simulation in pressurized solidification during squeeze casting of aluminum alloy A356

Numerical Simulation of Squeeze Casting of Aluminum Alloy Flywheel Housing with Large Wall Thickness Difference and Complex Shape

Microstructure Simulation of Zl114a Alloy During Low Pressure Die Casting Process

Determination of casting parameters of thick wall die-casting of magnesium alloy and simulation of its processing

Study on Numerical Simulation of Mold Filling and Solidification Processes under Pressure Conditions

Study on Macro- and Micromodeling of the Solidification Process of Aluminum Shape Casting

Numerical Simulation of Filling and Solidification Processes for Magnesium Alloy in Low Pressure Cast Process

Study on Numerical Simulation of Mold Filling and Heat Transfer in Die Casting Process

Accurate Simulation of Complex Temperature Field in Counter-Pressure Casting Process Using A356 Aluminum Alloy

Low pressure casting technology and forming process analysis of metal mold based on ProCAST FEA procedure

SIMULATION OF ALUMINUM FIXTURE PART HOT EXTRUSION PROCESS WITH THE FINITE VOLUME METHOD

The Challenge and Progress in Macro- and Micro-modeling and Simulation of Squeeze Casting Process

AN ELASTIC-VISCOPLASTIC CONSTITUTIVE MODEL FOR SQUEEZE CASTING ALUMINUM ALLOY

Thermomechanical Modeling of Solidification Process of Squeeze Casting Ii. Numerical Simulation and Experimental Validation