Abstract:The present paper focuses on the heat transfer and contact pressure at the casting-die interface in squeeze casting process. Experiments were conducted and a "plate shape" was used to cast aluminum alloy A356 in H13 steel die. Based on the temperature measurements inside the die, the interfacial heat transfer coefficient (IHTC) at the metal-die interface was determined by applying an inverse approach. The pressure at the metal-die interface was measured by using Kistler pressure transducer. The acquired data were processed by a low pass filtering method based on Fast Fourier Transform (FFT). Besides, a set of methods was set up to verify the computer program for the inverse model. The results show that the pressure at the casting-die interface and the IHTC rose to the peak value almost simultaneously as soon as the pressure was applied by the press. The higher the applied pressure, the higher the peak value of the IHTC and the pressure at the casting-die interface. It was a pressure maintaining stage immediately after the pressure was applied. During this stage, the pressure at the casting-die interface decreased immediately after it reached the peak value. The IHTC sharply dropped at the beginning. Then, the decrease rate of the IHTC became lower and lower. Besides, the IHTC of the cases with pressure applied was much higher than those without pressure applied. It indicates that the applied pressure greatly improved the contact status of casting and die surfaces and reduced the thermal resistance between the two surfaces. The IHTC profiles of the cases with the pressures 23 MPa and 46 MPa applied did not make much difference, however, when the applied pressure reached 70 MPa, the influence of the pressure at the casting die interface on the IHTC became very remarkable. (C) 2017 Elsevier Ltd. All rights reserved.

Accurate Simulation of Complex Temperature Field in Counter-Pressure Casting Process Using A356 Aluminum Alloy

Simulation Analysis of Thermal Stress During Casting Process of Large-Sized Alloy Steel Ingot

Numerical Simulation of Filling and Solidification of Large Complex ZTC4 Alloy Castings

Simulation of filling and solidification processing of large complex ZTC4 castings

Simulation on Die Casting Process for Magnesium Alloy Steering Wheel Frame

Numerical Simulation of the Pressure Casting Process for Magnesium Alloy Steering Wheel

Numerical Simulation and Experimental Investigation of Microstructure Evolution and Flow Behavior in the Rheological Squeeze Casting Process of A356 Alloy

Numerical simulation and experimental research on the cooling-controlled technology for high strength aluminums alloy ingots

Numerical Simulation of Semi-Solid Die-Casting Process of Automobile Aluminum Alloy Part

Heat Transfer and Stress Evolution Behaviours of an Aluminium Alloy Low Pressure Shell Casting

Numerical Simulation of Temperature Field and Grain Structure in Cu-10Al Alloy Produced by Heated Mould Continuous Casting

Simulation of Fine Grain Casting Process of Superalloy K4202 by Thermal Control Method

Numerical modeling of the heat treatment with residual heat of aluminum castings

Numerical simulation of 7050 aluminum alloy semi-solid squeeze casting

Numerical Simulation of Squeeze Casting of Aluminum Alloy Flywheel Housing with Large Wall Thickness Difference and Complex Shape

Numerical Simulation on Rheocasting of Aluminum Alloy and Experimental Verification

Simulation and Experiment Research on Integrated Casting and Forging Process of Automobile Control Arm

Experimental Study on the Heat Transfer Behavior and Contact Pressure at the Casting-Mold Interface in Squeeze Casting of Aluminum Alloy

Design and Simulation Optimization of Casting Process for Aluminum Alloy Engine Cylinder Head

Numerical Simulation of Process of Cavity Filling and Solidifying in Tial Alloy Investment Casting

Melt Quality of A356.2 Alloy in the Pressure Counter Pressure Casting Process for Steering Knuckles