Abstract:ZL205A alloys are prone to generate serious residual stress due to the long solidification intervals and multiphase composition. In this study, the low-pressure casting process for ZL205A alloy hemisphere shell casting was investigated and continuously optimized. In the initial process, the knockout time, pouring temperature, preheating temperature of the sand mould, dwelling pressure, and filling rate were 3 h, 710 degrees C, 30 degrees C, 65 kPa, and 0.33 kPa center dot s(-1), respectively. Macroscopic properties and microstructural features were simulated using a combination of ProCAST and Thermal-Calc software. Additionally, a series of experimental procedures, including EBSD, SEM, EDS, and XRD tests, were conducted to investigate the formation, morphology, and distribution of the microstructure. Current findings demonstrate that during the solidification process, the maximum temperature difference exceeds 220 degrees C, the maximum undercooling reaches 49.56. degrees C, and the maximum effective stress peaks at 301.7 MPa. The residual stress ranges from 20 to 200 MPa. Furthermore, there is no significant texture and preferred grain orientation during nucleation and solidification, and the structure field exhibits an equiaxed crystal but inhomogeneous pattern. Moreover, the finer and more homogeneous the grains and the smaller the deviation in grain orientation, the lower the residual stress. Specifically, two analytical models are developed: one between the casting parameters and the residual stress, and another between the shrinkage defects and the casting parameters. The lowest residual stress is achieved when the knockout time, pouring temperature, pre-heating temperature of the sand mould, dwelling pressure, and filling rate are 6 h, 725 degrees C, 250 degrees C, 95 kPa, and 1.67 kPa center dot s(-1) respectively.

Microstructure phase analysis and process optimization of ZL205A metal mold casting

Die Structure Optimization of Aluminum Alloy Wheel Low-Pressure Die Casting Based on CAE

Process Optimization of Low-pressure Die Casting of Aluminum Alloy Wheel based on Taguchi Method

Determination of casting parameters of thick wall die-casting of magnesium alloy and simulation of its processing

Microstructure of Zn-Al4 alloy microcastings by micro precision casting based on metal mold

Experimental study of squeeze casting of ZK60 magnesium alloy

Optimization of residual stress in low-pressure casting of ZL205A alloys

Microstructure Simulation of Zl114a Alloy During Low Pressure Die Casting Process

Eliminating shrinkage defects and improving mechanical performance of large thin-walled ZL205A alloy castings by coupling travelling magnetic fields with sequential solidification

Research of Die-Casting Process of ZA85 Magnesium Alloys

Numerical Simulation and Experimental Investigation of Microstructure Evolution and Flow Behavior in the Rheological Squeeze Casting Process of A356 Alloy

Production of ZL205A Alloy Shell Castings by Low Pressure Casting

Simulation Analysis on Micro Hole Forming of Aluminum Alloy in Extrusion Casting Process

Effect of Process Parameters on the Mechanical Properties and Microstructure of Large-Sized Aluminum Alloy Parts with Complex Shape Formed by Squeeze Casting

Optimization of low-pressure die casting process parameters for reduction of shrinkage porosity in ZL205A alloy casting using Taguchi method

Experiment and Numerical Simulation of Microstructure of ZL114A Alloy in Low Pressure Casting

Optimization of squeeze casting process of gearbox cover based on FEM and Box-Behnken design

Optimization and Design Based On Numerical Simulation of AZ91D Die Casting Gating and Runner System

Eliminating Defects of ZnAl Alloy by Squeeze Casting or Liquid Extrusion

Low pressure casting technology and forming process analysis of metal mold based on ProCAST FEA procedure

Achieving refined microstructures and improved mechanical properties in a cup-shaped Mg-Gd-Y-Zr alloy casting by novel near-liquidus squeeze cast process