Abstract:This paper carried out numerical simulations of the entire process of rheological squeeze casting of A356 alloy, evaluated the impact of various combinations of forming process parameters on the temperature field, flow field, and solid-phase fraction of A356 semi-solid slurry, and studied the influence of die temperature (°C) and filling speed (mm/s) on the microstructure formation mechanism of A356 alloy rheological squeeze castings. The research revealed that A356 alloy castings with diverse microstructural features can be achieved by solely controlling the rheological squeeze casting process parameters, without the use of additional heterogeneous nucleating agents or heat treatment. Through combined numerical simulation and experimental results, the optimal rheological squeeze casting process parameters were determined: filling speed of 20 mm/s and mold temperature of 350 °C. It was observed that with the simultaneous increase of mold temperature and filling speed, the average equivalent diameter of the α -Al phase significantly increased from 26.18 μm to 44.27 μm, the uniformity of the eutectic structure distribution was greatly improved, and it was also found that the excessively high filling speed is a critical factor contributing to the coexistence of the script-shaped π -Al 8 FeMg 3 Si6 phase and the undecomposed the needle-like β -Al 5 FeSi phase.

Thermomechanical Modeling of Solidification Process of Squeeze Casting Ii. Numerical Simulation and Experimental Validation

Thermomechanical Modeling of Solidification Process of Squeeze Casting I. Mathematic Model and Solution Methodology

A Thermomechanical Finite Element Model for Simulating the Solidification Process of Squeeze Casting

Numerical Simulation and Optimization of Indirect Squeeze Casting Process

Microstructure simulation in pressurized solidification during squeeze casting of aluminum alloy A356

Continuous Casting Mould for Square Steel Billet Optimised by Solidification Shrinkage Simulation

AN ELASTIC-VISCOPLASTIC CONSTITUTIVE MODEL FOR SQUEEZE CASTING ALUMINUM ALLOY

Numerical Simulation and Experimental Investigation of Microstructure Evolution and Flow Behavior in the Rheological Squeeze Casting Process of A356 Alloy

Integrated Numerical Simulations and Experimental Measurements for the Sintering Process of Injection-Molded Ti-6Al-4V Alloy

A Study on the Numerical Simulation of Thermal Stress During the Solidification of Shaped Castings

Numerical simulation analysis of thermal stress fields during solidification of steel casting

The Challenge and Progress in Macro- and Micro-modeling and Simulation of Squeeze Casting Process

A quantitative model for describing crystal nucleation in pressurized solidification during squeeze casting

A Mathematical Model for Simulating the Microporosity of Squeeze Casting of Aluminum Alloy

Application of Modeling and Simulation of Thermal Stress in Solidification Process of a Heavy Steel Casting

Study on numerical simulation of mold-filling and solidification processes of shaped casting

Progress in numerical simulation of solidification process of shaped casting

Numerical Methods to Improve the Computational Efficiency of Solidification Simulation for the Investment Casting Process

Simulation Analysis on Micro Hole Forming of Aluminum Alloy in Extrusion Casting Process

Study on Numerical Simulation of Mold Filling and Solidification Processes under Pressure Conditions

Progress on Numerical Simulation of Mold Filling and Solidification Processes of Shaped Castings