Abstract:To predict the heat transfer behavior of A380 alloy in a shot sleeve, a numerical approach (inverse method) is used and validated by high pressure die casting (HPDC) experiment under non-shooting condition. The maximum difference between the measured and calculated temperature profiles is smaller than 3 °C, which suggests that the inverse method can be used to predict the heat transfer behavior of alloys in a shot sleeve. Furthermore, the results indicate an increase in maximum interfacial heat flux density (q max) and heat transfer coefficient (h max) with an increase in sleeve filling ratio, especially at the pouring zone (S2 zone). In addition, the values of initial temperature (T IDS) and maximum shot sleeve surface temperature (T simax) at the two end zones (S2 and S10) are higher than those at the middle zone (S5). Moreover, in comparison with fluctuations in heat transfer coefficient (h) with time at the two end zones (S2 and S10), 2.4-6.5 kW∙m-2∙K-1, 3.5-12.5 kW∙m-2∙K-1, respectively, more fluctuations are found at S5 zone, 2.1-14.7 kW∙m-2∙K-1. These differences could theoretically explain the formation of the three zones: smooth pouring zone, un-smooth middle zone and smooth zone, with different morphologies in the metal log under the non-shot casting condition. Finally, our calculations also reveal that the values of q max and h max cast at 680 °C are smaller than those cast at 660 °C and at 700 °C.

3D Numerical Simulation of Temperature Field Coupled with Flow Field of the Liquid Metal in Shot Sleeve of Die Casting Process

Numerical simulation and optimization of liquid metal flow in the shot sleeve of cold chamber die casting process

Numerical Simulation on the Liquid Metal Flow of the Acceleration Phase in the Shot Sleeve of Cold Chamber Die Casting Process

Study on Numerical Simulation of Mold Filling and Heat Transfer in Die Casting Process

The Numerical Simulation of Flow Field of the Slow Shot Phase in the Shot Sleeve

Numerical Simulation of Fluid Flow and Heat Transfer During Mold Filling for Die Casting

Water Analogue Validation of Numerical Model for Fluid Flow During Slow Shot Phase in Die Casting Process

Development and Application of Inverse Heat Transfer Model Between Liquid Metal and Shot Sleeve in High Pressure Die Casting Process under Non-Shooting Condition

Numerical Simulation of Fluid Flow and Solidification in Continuous Slab Casting Mould Based on Inverse Heat Transfer Calculation

Numerical Simulation and Optimization of Indirect Squeeze Casting Process

Numerical simulation and experimental verification of the initial temperature distribution of castings during mold filling process

Numerical Methods to Improve the Computational Efficiency of Thermal Analysis for the Die Casting Process

Study and Application of Mold Filling Simulation of Shaped Castings

Multiphase modelling of the transient flow for Sn-15Pb and 357.0 alloys in semi-solid die casting process

Numerical Simulation of the Flow Field in an Ultrahigh-Speed Continuous Casting Billet Mold

3D Transient Heat Transfer Simulation and Optimization for Initial Stage of Steel Continuous Casting Process

Modeling Coupled Fluid Flow and Heat Transfer During the Low Pressure Casting Process of Thin-Walled Plate Castings

Numerical simulation for mold-filling and coupled heat transfer processes of titanium shaped castings under centrifugal forces

Progress in numerical simulation of solidification process of shaped casting

Numerical simulation of flow-induced air entrapment defects in the high pressure die casting process

Optimization of Slow Shot Parameters in a Die Casting Process by Numerical Simulation Technique