Abstract:Ultrasonic wedge bonding of aluminum (Al) wires is a widely applied interconnect technology for power elec-tronic packaging. The joint quality of the wedge bonding is mainly affected by the process parameters and material properties. Inappropriate process parameters will lead to failure modes such as chip surface pit, metal layer peeling off, wire cracking, non-sticking to the pad, etc., which limits the long-term stability of power devices. In order to reach the desired reliability, the design of experiment (DoE) is generally deployed which is costly in terms of time and related materials. Therefore, simulation-assisted analysis is in demand to rapidly narrow down the process windows. In this paper, an ultrasonic bonding model involving thick Al wires (300 mu m) was established based on the Finite Element Method (FEM), to optimize process parameters effectively with reduced time and cost. The model was designed in ANSYS utilizing the transient structural mechanics module with various stresses and ultrasonic power, to simulate the relative deformation of the bonded wires and the displacement against the substrate. The result was then verified by ultrasonic wedge bonding samples with 9 sets of process parameters. The stress distributions were simulated and analyzed with the failure modes of tensile strength tests, while the deformation of wires under various process parameters was measured and compared with shear strength tests. Further, the relationship between the failure modes of the joint and the deformation was then analyzed by Response Surface Method (RSM), and the regression equation of the wire deformation and related process parameters was established and fitted with the actual sample's data. Such analysis not only found the optimum range of the deformation of thick Al ultrasonic wire bonds but also quickly provided a range of optimized processes for Al thick wires applying ultrasonic wedge bonding techniques.

Wafer-to-Wafer Hybrid Bonding Development by Advanced Finite Element Modeling for 3-D IC Packages

Modelling and characterization on wafer to wafer hybrid bonding technology for 3D IC packaging

Simulation and Experimental Analysis of Thermomechanical Stress Around Interconnects for W2W Hybrid Bonding

Al-clad Cu Bond Wires for Power Electronics Packaging: Microstructure Evolution, Mechanical Performance, and Molecular Dynamics Simulation of Diffusion Behaviors

Optimization of Cu protrusion of wafer-to-wafer hybrid bonding for HBM packages application

Thermal Finite Element Simulation of Ultrafine Pitch Chip-to-Wafer Hybrid Bonding

Process Development of A New Tgv Interposer for Wafer Level Package of Inertial Mems Device

Development of low temperature Cu Cu bonding and hybrid bonding for three-dimensional integrated circuits (3D IC)

A Novel Nontraditional Approach to C2W Cu/SiO2 Hybrid Bonding

Cu-Based Thermocompression Bonding and Cu/Dielectric Hybrid Bonding for Three-Dimensional Integrated Circuits (3D ICs) Application

Hybrid Bonding for Ultra-High-Density Interconnect

Development of Hybrid Bonding Process for Embedded Bump with Cu-Sn/BCB Structure

A Wafer-Level 3d Integration Using Bottom-Up Copper Electroplating And Hybrid Metal-Adhesive Bonding

Three-dimensional hybrid bonding integration challenges and solutions toward multi-wafer stacking

Navigating Complex Process and Design Challenges in Hybrid Bonding for Advanced Semiconductor Integration: A Comprehensive Analysis

Enhancement of the Bond Strength and Reduction of Wafer Edge Voids in Hybrid Bonding

Fabrication of Complicated Three Dimensional Structures Utilizing Multi-Stack Bonding

Study on Electro-Thermo-Mechanical Responses of Bonding Wires Arrays Used for the Package Design of Ldmosfet-Based Rf Amplifier

Chip-to-wafer (C2W) 3D integration with well-controlled template alignment and wafer-level bonding

Finite element modeling and analysis of ultrasonic bonding process of thick aluminum wires for power electronic packaging

Enabling Ultra-Thin Die to Wafer Hybrid Bonding for Future Heterogeneous Integrated Systems