Abstract:In this work, a three-dimensional finite element model of a newly structured high-speed continuous casting mold was established to study the heat transfer and solidification process of the billet shell. A complete billet shell, from the meniscus to the secondary cooling zone, was obtained through flame cutting. Using both simulations and test verification, detailed analyses were conducted on the temperature field distribution, thickness variation law, and cooling rate law of the billet shell within the mold, revealing its solidification behavior. Additionally, the effects of casting speed, molten steel superheat, and mold taper on the solidification behavior of the billet shell were discussed. Results showed that the simulation data were basically consistent with the test verification results. Within 200 mm from the meniscus, the heat dissipation accounted for three-quarters of the mold's total heat dissipation. The cooling rate at the corners of the billet shell was slightly higher than that at the sides. Between 200 mm and 400 mm from the meniscus, air gaps caused the temperature at the corners of the billet shell to rise. Afterwards, the whole billet shell eventually reached a similar the heat dissipation rates. The thickness of the billet shell increased exponentially within 110 mm from the curved meniscus, and from 110 mm to the exit of the mold, the thickness increased linearly but slowly. The effect of molten steel superheat within a range of 10 °C on billet shell solidification was relatively minor. Increasing the casting speed reduced the billet shell thickness and raised the billet shell surface temperature. However, increasing the taper of the mold had the opposite effect. Both adjustments shifted the gap formation position backward.

Coupled Mathematical Model of Thermal Stress for Initial Shell of Groove Continuous Casting Mold

Simulation Analysis of Thermal Stress During Casting Process of Large-Sized Alloy Steel Ingot

Continuous Casting Mould for Square Steel Billet Optimised by Solidification Shrinkage Simulation

Analysis of Thermomechanical Behavior in Continuous Bloom Casting Mold

Thermomechanical Model of Heat Transffer in Bloom Casting Mold

Analysis of heat transfer and thermal stress in continuous casting with mechanical reduction

A coupled model on fluid flow, heat transfer and solidification in continuous casting mold

Thermo-mechanical Modeling in Continuous Slab Casting Mould and Its Application

Finite element numerical simulation on Thermo Mechanical couple in bloom mold

Thermal stress simulation considering mechanical interaction between casting and mold

Numerical Simulation on Thermo-Mechanical Coupling in Bloom Mold by Finite Element Method

Thermal Stresses in a Cylinder Block Casting Due to Coupled Thermal and Mechanical Effects

Finite Element Analysis of Shell Growth in a Continuous Casting Mold

Thickness Distributions of Mold Flux Film and Air Gap in Billet Ultra-High Speed Continuous Casting Mold Through Multiphysics Modeling

Hydraulic Modeling on Flow Behavior in High-Speed Billet Continuous Casting Mold Considering Hydrostatic Pressure and Solidified Shell

A Study on the Numerical Simulation of Thermal Stress During the Solidification of Shaped Castings

A 3D model coupled inverse algorithm for the non-uniform thermal behavior of a continuous casting mold

Finite Element Thermal-Mechanical Coupled Analysis of Strand Bulging Deformation in Continuous Casting

Study on solidification and heat transfer of billet shell in a new-structure high-speed continuous casting mold

INTEGRATED FINITE ELEMENT MODEL FOR TRANSIENT FLUID FLOW AND THERMAL STRESSES DURING CONTINUOUS CASTING

Chamfer and Taper Researches of Mould in Slab Continuous Casting