Abstract:The present paper focuses on the heat transfer and contact pressure at the casting-die interface in squeeze casting process. Experiments were conducted and a "plate shape" was used to cast aluminum alloy A356 in H13 steel die. Based on the temperature measurements inside the die, the interfacial heat transfer coefficient (IHTC) at the metal-die interface was determined by applying an inverse approach. The pressure at the metal-die interface was measured by using Kistler pressure transducer. The acquired data were processed by a low pass filtering method based on Fast Fourier Transform (FFT). Besides, a set of methods was set up to verify the computer program for the inverse model. The results show that the pressure at the casting-die interface and the IHTC rose to the peak value almost simultaneously as soon as the pressure was applied by the press. The higher the applied pressure, the higher the peak value of the IHTC and the pressure at the casting-die interface. It was a pressure maintaining stage immediately after the pressure was applied. During this stage, the pressure at the casting-die interface decreased immediately after it reached the peak value. The IHTC sharply dropped at the beginning. Then, the decrease rate of the IHTC became lower and lower. Besides, the IHTC of the cases with pressure applied was much higher than those without pressure applied. It indicates that the applied pressure greatly improved the contact status of casting and die surfaces and reduced the thermal resistance between the two surfaces. The IHTC profiles of the cases with the pressures 23 MPa and 46 MPa applied did not make much difference, however, when the applied pressure reached 70 MPa, the influence of the pressure at the casting die interface on the IHTC became very remarkable. (C) 2017 Elsevier Ltd. All rights reserved.

Thermal Stresses in a Cylinder Block Casting Due to Coupled Thermal and Mechanical Effects

Simulation Analysis of Thermal Stress During Casting Process of Large-Sized Alloy Steel Ingot

Thermal stress simulation considering mechanical interaction between casting and mold

Review on the Interface Interaction Between the Casting and Mold(Core) in Thermal Stress Analysis of Castings

A Study on Heat Transfer Model for the Dynamic Contact Boundary Between Piston Ring and Cylinder Liner

Numerical simulation analysis of thermal stress fields during solidification of steel casting

Study on Thermoelastic Contact of Cylinder Head-Cylinder Head Gasket-Engine Block

A Study on the Numerical Simulation of Thermal Stress During the Solidification of Shaped Castings

Numerical Simulation of Thermal Stress of Diesel Engine Cylinder Block Castings Under Two Different Constraints

Thermal stresses analysis of an engine cylinder block casting based on finite difference Meshes

Study on Dynamic Measurement of Thermal Stress during Solidification of a Casting Specimen

Thermal Stress Analysis of the Solidification Process of Francis Turbine Band Casting

Application of Modeling and Simulation of Thermal Stress in Solidification Process of a Heavy Steel Casting

Analysis of thermal-mechanical coupling strength and fatigue life of cylinder head

Coupled Mathematical Model of Thermal Stress for Initial Shell of Groove Continuous Casting Mold

Analysis of heat transfer and thermal stress in continuous casting with mechanical reduction

Numerical simulation of thermal stress in diesel engine cylinder block castings during solidification process under different shake-out conditions

Experimental Study on the Heat Transfer Behavior and Contact Pressure at the Casting-Mold Interface in Squeeze Casting of Aluminum Alloy

INTEGRATED FINITE ELEMENT MODEL FOR TRANSIENT FLUID FLOW AND THERMAL STRESSES DURING CONTINUOUS CASTING

Integrated Simulation of Castings Deformation during Casting and Heat Treatment Processes

Numerical Simulation of Thermal Stress and Deformation of Engine Block Iron Casting