Abstract:The present paper focuses on the heat transfer and contact pressure at the casting-die interface in squeeze casting process. Experiments were conducted and a "plate shape" was used to cast aluminum alloy A356 in H13 steel die. Based on the temperature measurements inside the die, the interfacial heat transfer coefficient (IHTC) at the metal-die interface was determined by applying an inverse approach. The pressure at the metal-die interface was measured by using Kistler pressure transducer. The acquired data were processed by a low pass filtering method based on Fast Fourier Transform (FFT). Besides, a set of methods was set up to verify the computer program for the inverse model. The results show that the pressure at the casting-die interface and the IHTC rose to the peak value almost simultaneously as soon as the pressure was applied by the press. The higher the applied pressure, the higher the peak value of the IHTC and the pressure at the casting-die interface. It was a pressure maintaining stage immediately after the pressure was applied. During this stage, the pressure at the casting-die interface decreased immediately after it reached the peak value. The IHTC sharply dropped at the beginning. Then, the decrease rate of the IHTC became lower and lower. Besides, the IHTC of the cases with pressure applied was much higher than those without pressure applied. It indicates that the applied pressure greatly improved the contact status of casting and die surfaces and reduced the thermal resistance between the two surfaces. The IHTC profiles of the cases with the pressures 23 MPa and 46 MPa applied did not make much difference, however, when the applied pressure reached 70 MPa, the influence of the pressure at the casting die interface on the IHTC became very remarkable. (C) 2017 Elsevier Ltd. All rights reserved.

Review on the Interface Interaction Between the Casting and Mold(Core) in Thermal Stress Analysis of Castings

Simulation Analysis of Thermal Stress During Casting Process of Large-Sized Alloy Steel Ingot

Thermal stress simulation considering mechanical interaction between casting and mold

Numerical simulation analysis of thermal stress fields during solidification of steel casting

Thermal Stresses in a Cylinder Block Casting Due to Coupled Thermal and Mechanical Effects

A Study on the Numerical Simulation of Thermal Stress During the Solidification of Shaped Castings

Thermal Stress Analysis of the Solidification Process of Francis Turbine Band Casting

Application of Modeling and Simulation of Thermal Stress in Solidification Process of a Heavy Steel Casting

Numerical Simulation of Thermal Stress of Shaped Casting Based on Rheological Model

Analysis of heat transfer and thermal stress in continuous casting with mechanical reduction

Progress in numerical simulation of casting process

Study on numerical simulation of mold-filling and solidification processes of shaped casting

Study on Dynamic Measurement of Thermal Stress during Solidification of a Casting Specimen

Numerical Simulation of Thermal Stresses of Castings During Solidification Based on Personal Computer and Its Engineering Application

Continuous Casting Mould for Square Steel Billet Optimised by Solidification Shrinkage Simulation

Integrated Simulation of Castings Deformation during Casting and Heat Treatment Processes

Modeling on Stress Evolution of Step Part for Casting-Heat Treatment Processes

Numerical Methods to Improve the Computational Efficiency of Thermal Analysis for the Die Casting Process

Numerical simulation and experimental verification of the initial temperature distribution of castings during mold filling process

Experimental Study on the Heat Transfer Behavior and Contact Pressure at the Casting-Mold Interface in Squeeze Casting of Aluminum Alloy

Thermo-mechanical Modeling in Continuous Slab Casting Mould and Its Application