Abstract:Using molecular dynamics (MD) simulation, the deformation mechanisms of gradient nanograined (GNG) pure iron (Fe) were investigated. Simulations of uniaxial tensile experiments were conducted on samples exhibiting different grain size gradients (GSGs). The simulation results reveal the presence of a critical GNG parameter (g), at which point the GNG-Fe attains its highest strength. The deformation mechanisms of three representative samples, namely GNG-2 with the g value at the threshold, GNG-1 with a g value smaller than the critical threshold and GNG-4 with a g value exceeding it, were thoroughly investigated. Within the coarse-grained (CG) region of GNG-1, the primary deformation mechanism is predominantly characterized by planar defects, rather than being dominated by dislocations. The mechanisms of both "strain hardening" and "softening" were observed and discussed in this region. The deformation of the coarse grains occurs in a coordinated manner, and the magnitude of the back-stress is insufficient to trigger grain boundary (GB) motion in the fine-grained (FG) region. In contrast, the deformation of the CG region in the GNG-4 primarily depends on dislocation. The "hardening" and "softening" effects of the dislocations were discussed. In the FG region of GNG-4, the grains undergo deformation primarily through GB motion, a phenomenon attributed to the significant back-stress generated by the uncoordinated deformation exhibited by the coarse grains. In the CG area of sample 2 with the g value at threshold, both dislocation- and planar defects-controlled mechanisms are observed. In the FG of this sample, neither GB migration and grain rotation are found. Only the GB width becomes larger, indicating that the back-stress transferred from the CG area makes the GB more active, but not large enough to induce the GB migration or grain rotation. The results of this work may provide some theoretical supports for the deformation mechanism of the GNG materials.

Effect of grain size on subsurface characterization of pure iron subjected to orthogonal cutting

Experimental Research on the Effect of Grinding Parameters on Ceramic Machined Surface Roughness

Grain size influence on chip formation in high-speed machining of pure iron

Finite Element Simulation Of High-Speed Cutting Alloy Cast Iron

Numerical simulation on surface residual stress for titanium alloy

Study on the Effect of Tool Inclination Angle in Machining Process Based on Three-Dimensional Thermo-Elastic-Plastic Model

Study on Cutting Force, Cutting Temperature and Machining Residual Stress in Precision Turning of Pure Iron with Different Grain Sizes

Molecular Dynamics Simulation Study on the Influence of the Abrasive Flow Process on the Cutting of Iron-Carbon Alloys (α-Fe)

Effects of grain size of AISI 304 on the machining performances in micro electrical discharge machining

Effect of grain size gradient on the mechanical behavior of gradient nanograined pure iron: an atomic study

Effect of Grain Size on Nanometric Cutting of Polycrystalline Silicon via Molecular Dynamics Simulation

Plastic Yielding and Tensile Strength of Near-Micrometer Grain Size Pure Iron

Atomic simulation for the effect of nano-cutting parameters on the 3D surface morphology of polycrystalline γ-TiAl alloy

Effects of Processing Parameters and Tool Geometric Parameters on Residual Stress of Machined 304 Stainless Steel

Effect of machining processes on the quenching and tempering surface layer of ultra-high strength steel

Effect of single/multi-particle grinding parameters on surface properties of bearing steel GCr15

Research on the effect of cutting parameters on the machinability of polycrystalline Fe-Cr-W alloy by molecular dynamics simulation

Effect of Electroplastic-Assisted Grinding on Surface Quality of Ductile Iron

Finite element simulation of residual stress in machining of Ti-6Al-4V with a microstructural consideration

Experimental Study on the Surface Integrity and Chip Formation in the Micro Cutting Process

Effect of Grain Size on the Plastic Deformation Behaviors of a Fe-18Mn-1.3Al-0.6C Austenitic Steel