Abstract:Grinding force model is an important tool for the selection and optimization of ultrasonic-assisted grinding of advanced ceramics. Meanwhile, there is still a lot of room for performance improvement and application expansion. In particular, it is generally recognized that the grinding wheel wear state directly affects the accuracy of grinding force model. To address these issues, a model for predicting the grinding force during ultrasonic-assisted face grinding (UAFG) of advanced ceramic materials was proposed in the present work based on the material removal mechanisms and the friction characteristics of the grain–workpiece interface under the action of ultrasonic vibration. UAFG tests were carried out on ZrO 2 ceramics to verify the accuracy of the model. The results show that the average discrepancies between the predicted and measured normal and tangential forces are 7.4% and 8.1%, respectively. Finally, the tool wear tests reveal that with the gradual wear of the tool, the grinding force first decreases and then increases, and the accuracy of the model follows the opposite trend. Furthermore, the abrasive wear state has a significant effect on the surface material removal mechanism during ultrasonic-assisted grinding. When the cutting-edge morphology is regular and micro-crushed abrasive grains are predominant, the material removal mechanism is a combination of plastic removal and brittle fracture. When macro-crushed abrasive grains and abrasive fracture prevail, the material removal mechanism is dominated by brittle fracture, while the material removal mechanism is dominated by plastic removal when abrasive platform is predominant.

Experimental Research on the Effect of Grinding Parameters on Ceramic Machined Surface Roughness

Influences of Grinding Parameters on Forces in the Grinding of Microwave Ferrite Ceramic with Electroplated Diamond Wheel

Influences of grinding parameters on flexural strength in the grinding of Li-spinel ferrites with electroplated diamond wheel

Experimental investigation on grinding-induced surface damage of Fiber Reinforced Ceramic Matrix Composites

Study on the Correlativity Between Grinding Parameters and Surface Residual Stresses in Ceramic

Experimental Reasearch on Grinding Surface Waviness of Engineering Ceramics

Effect of Ultrasonic Vibration Assisted Grinding Process on Surface Topography and Properties of C/SiC Composite

An Experimental Investigation on Ultrasonic Vibration-Assisted Grinding of Sio2f/Sio2 Composites

Research on the System Matching Model in Ultrasonic Vibration-Assisted Grinding

Influence of diamond wheel grinding process on surface micro-topography and properties of SiO2/SiO2 composite

Investigations on Grinding Process of Woven Ceramic Matrix Composite Based on Reinforced Fiber Orientations

Studies on the Surface Quality of the Unsteady-State Grinding Technique

Influence of Thermal-mechanical Coupling of Single Particle on Grinding Surface Roughness

Effect of grinding parameters on surface quality in internal grinding of silicon nitride ceramics

Comprehensive analysis of the effects of different parameters on the grinding performance for surfaces

Effects of Abrasive Material and Hardness of Grinding Wheel on Rail Grinding Behaviors

Research on Microscopic Grain-Workpiece Interaction in Grinding through Micro-Cutting Simulation, Part 2: Factorial Study

Grinding force modeling in ultrasonic-assisted face grinding of ZrO2 ceramics and influence of grinding wheel wear on its accuracy

Optimization of the grinding process to improve the surface integrity of bearing raceways

Diamond wheel grinding characteristics of 3D orthogonal quartz fiber reinforced silica ceramic matrix composite

Effect of single/multi-particle grinding parameters on surface properties of bearing steel GCr15