Abstract:This manuscript delineates a predictive model for evaluation of residual stress phenomena in micro-machining operations, predicated upon the symbiotic dynamics of strain, strain rate, and thermal conditions. The objective is to scrutinize the ramifications of variable parameters such as machining velocity, axial depth of cut, and cutting tool’s rake angle on the resultant machining forces and induced residual stresses. By analyzing the interplay between the shear forces, frictional stresses, and the material deformation forces during micro-machining, alongside the correlation between shear velocity and material displacement, as well as thermal contributions in both primary and secondary deformation regions involving the substrate, removed material, and the cutting implement, the residual stresses are deduced employing the Johnson-Cook material behavior model, manifesting predominantly as compressive residual stresses within the work material. The veracity of the analytical model for residual stress is corroborated with the maximum relative discrepancies for principal cutting force and residual stress at 16.8% and 6.53%, respectively, both falling under the 15% threshold, thus affirming the model’s precision. Empirical findings underscore the axial depth of cut as the most influential parameter on machining forces, with theoretical escalations of 183.84% and 145.67% in the orthogonal X and Y directions accordingly, as the depth of cut augments from 10 to 25 μm. Conversely, the machining velocity predominantly affects the thermal profile and residual stress levels; a surge in machining velocity from 400 to 800 mm/min correlates with a theoretical amplification in thermal generation by 227.52%, while concurrently registering a decrement in residual stress magnitude by 7.08%.

Effects of Processing Parameters and Tool Geometric Parameters on Residual Stress of Machined 304 Stainless Steel

Effects of low-cycle fatigue on static mechanical properties, microstructures and fracture behavior of 304 stainless steel

Study on the Effect of Tool Inclination Angle in Machining Process Based on Three-Dimensional Thermo-Elastic-Plastic Model

Numerical investigation of sequential cuts residual stress considering tool edge radius in machining of AISI 304 stainless steel

Analytical modeling of milling residual stress under different tool wear conditions

Numerical and experimental investigation of tool geometry effect on residual stresses in orthogonal machining of Inconel 718

Prediction of residual stress with multi-physics model for orthogonal cutting Ti-6Al-4V under various tool wear morphologies

Analysis and Simulation of Machining Deformation Resulting from Residual Stress

Finite element simulation of residual stress in machining of Ti-6Al-4V with a microstructural consideration

Study on the Evolution of Residual Stress in Successive Machining Process

FEM Analysis of Residual Stress Distribution and Cutting Forces in Orthogonal Cutting with Different Initial Stresses

Prediction of Surface Residual Stress after End Milling Based on Cutting Force and Temperature

Simulation Study of Cutting-Induced Residual Stress

Effects of Strain Hardening and Initial Yield Strength on Machining-Induced Residual Stresses

Finite Element Method Study on the Influence of Initial Stress on Machining Process

Effects of Multi-Pass Turning on Stress Corrosion Cracking of AISI 304 Austenitic Stainless Steel

Construction of a predictive model for residual stresses in micro-milling of 7075 aluminum alloy

Comprehensive Impact of Machined Surface Integrity on Stress Corrosion Cracking Initiation in 316 Austenitic Stainless Steel

Residual Stress Generation in Grinding: Mechanism and Modeling

Combined effects of machining-induced residual stress and external load on SCC initiation and early propagation of 316 stainless steel in high temperature high pressure water

Investigation on residual stress evolution in nickel-based alloy affected by multiple cutting operations