Abstract:Machining-induced residual stresses in a part can significantly influence its performance and service time. It is common that the final surface of the part is produced after multiple cuts in the machining process. In multiple cuts, the previous cuts could often generate accumulated strain/stress and temperature on the part surface. These accumulated strain/stress and temperature will be brought to the subsequent cut or final cut and continuously affect the cutting forces, process temperatures, deformation zones, etc. in subsequent cut, and eventually affect the final residual stresses on the part. This paper reports on a joint experimental and numerical investigation to explore the influence of previous cuts on surface residual stresses with consideration of cutting parameters, cutting procedure, and tool geometries in multiple cut of Inconel 718 alloy. Coupled Eulerian and Lagrangian (CEL) formulation is used in a two/three-cuts numerical model. The loading cycles of the selected material nodes are characterised based on isotropic constitutive model (Johnson-Cook model) to analyse the underlying mechanism of residual stress evolution during cutting sequences. The results show that accumulated stress/strain induced by previous cuts lead to a more curled chip morphology, a slight decrease in cutting force and a slight increase in feed force in the subsequent cut. An increased magnitude and depth of compressive residual stresses in the finished workpiece are generated owing to the influence of previous cuts, and this is more obvious when the previous cut is implemented at a larger uncut chip thickness, using a more negative rake angle or a larger edge radius tool. The residual stress level might be controlled by optimizing the previous cuts to get the desired surface integrity.

Numerical investigation of sequential cuts residual stress considering tool edge radius in machining of AISI 304 stainless steel

Numerical simulation on surface residual stress for titanium alloy

Numerical and experimental investigations on residual stress evolution of multiple sequential cuts in turning

Investigation on residual stress evolution in nickel-based alloy affected by multiple cutting operations

Numerical investigations on residual stresses in orthogonal cutting of Ti-6A1-4V

Effects of Processing Parameters and Tool Geometric Parameters on Residual Stress of Machined 304 Stainless Steel

Evolution of residual stress when turning a fillet radius in stainless steel

Numerical and experimental investigation of tool geometry effect on residual stresses in orthogonal machining of Inconel 718

Numerical Modeling of the Effect of Cutting-Edge Radius on Cutting Force and Stress Concentration during Machining

Analytical modeling of milling residual stress under different tool wear conditions

Simulation Study on Residual Stress Distribution of Machined Surface Layer in Two-Step Cutting of Titanium Alloy

FEM Analysis of Residual Stress Distribution and Cutting Forces in Orthogonal Cutting with Different Initial Stresses

Evaluation of cutting edge K-form factor in milling of 316L stainless steel: a study based on FEM

Theoretical investigation of machining-induced residual stresses in longitudinal torsional ultrasonic–assisted milling

Prediction of residual stress with multi-physics model for orthogonal cutting Ti-6Al-4V under various tool wear morphologies

Residual stress prediction in ultrasonic vibration–assisted milling

Study on the Evolution of Residual Stress in Successive Machining Process

Study on Residual Stress Produced in Milling of Aeronautic Structure

Finite element simulation of residual stress in machining of Ti-6Al-4V with a microstructural consideration

Analysis and Simulation of Machining Deformation Resulting from Residual Stress

Effects of Strain Hardening and Initial Yield Strength on Machining-Induced Residual Stresses