Abstract:High-performance manufacturing (HPM) is essential for high-quality equipment and parts manufacturing, which requires not only geometric accuracy but also control of surface integrity to satisfy functional performance. Surface topography and residual stress are important elements of surface integrity. However, they are always investigated individually, and their collaborative formation pattern has been ignored for a long time. In this study, surface topography will be measured by a 3D laser scanning microscope and analyzed from the perspective of spectral wavelength ( λ ) along with its corresponding amplitude. Whereas the residual stress (RS) is going to be analyzed by X-Ray diffraction and finite element (FE) model. Thereafter we introduce the formation pattern of both surface topography and RS. Hereby, simulated points clouds of machined surface topography are generated by superimposing the normally distributed random numbers that take into account the springback of the workpiece material response on tool kinematics and geometry. Furthermore, the RS is divided into mechanical loads induced ( RS M ) and thermal loads induce ( RS T ) according to the mechanism of formation, which were obtained in cutting speed (Y-direction) and feed direction (Z-direction) by the Mohr circle. Our experimental and numerical results showed that an increase in the feed rate (from 0.05 mm/r to 0.15 mm/r) significantly increases the surface roughness and cutting temperature. The increase in temperature increased the RS T by up to 286.1%, resulting in a reduction of compressive RS in Z-direction and an increase of tensile RS in Y-direction. Moreover, the increase in cutting speed (from 40 m/min to 80 m/min) results in a more regular surface and a reduction in surface roughness because of the smaller springback. At the same time, it also leads to a decrease of RS M in Z-direction and an increase of RS M in Y-direction. In addition, the increment in cutting speed leads to a minor increase in temperature and RS T (maximum increase of 47.0%). Combining the effects of RS M and RS T , RS in both directions increases slightly.

Numerical and experimental investigations on residual stress evolution of multiple sequential cuts in turning

Numerical investigation of sequential cuts residual stress considering tool edge radius in machining of AISI 304 stainless steel

Numerical simulation on surface residual stress for titanium alloy

Evolution of residual stress when turning a fillet radius in stainless steel

Investigation on residual stress evolution in nickel-based alloy affected by multiple cutting operations

The Periodical Fluctuation of Residual Stress in Hard Turned Surface and Its Relationship with Chip Formation

Investigational Advances in Residual Stresses by Hard Turning

Study on the Evolution of Residual Stress in Successive Machining Process

Collaborative formation pattern of surface topography and residual stress in hard turning of steels

The Impact on the Residual Stress Distribution in Continuous Hard Turning GCr15

Optimization of process parameter of residual stresses for hard turned surfaces

Numerical investigations on residual stresses in orthogonal cutting of Ti-6A1-4V

A Framework to Efficiently Simulate the Cyclic Variation of the Residual Stresses Induced by Chip Formation in Machining of Ti-6Al-4 V Alloy

Simulation of Material Side Flow Using a 3D Coupled Eulerian-Lagrangian Approach and a Constitutive Model Considering the Stress State

Residual stresses in ultrasonic vibration assistance turning cemented carbide

Finite element simulation of residual stress in machining of Ti-6Al-4V with a microstructural consideration

Analytical modeling of milling residual stress under different tool wear conditions

On Predicting Residual Stress And Chip Morphology In Pre-Stressed Hard Turning

Study on Residual Stress Produced in Milling of Aeronautic Structure

Finite Element Simulation of Residual Stress on the Surface in the Cutting Considering Tool Flank Wear

Prediction of residual stress with multi-physics model for orthogonal cutting Ti-6Al-4V under various tool wear morphologies