Abstract:The excellent mechanical and physical properties of Ti6Al4V titanium alloy make it a good candidate material for a broad range of applications, with special relevance for the aerospace industry. As a difficult-to-cut alloy, it represents a great challenge to improve its machinability and surface integrity while simultaneously avoiding the high time consuming and cost of the experiments. Modelling and simulation of the machining process offer a cost-effective method to investigate the machining process. In this work, an orthogonal cutting model of Ti-6Al-4 V alloy was developed and used to simulate the major cutting outcomes, including: forces, temperature distribution, chip geometry, chip compression ratio and residual stresses in the machined surface and subsurface. This cutting model includes a constitutive model accounting for the state of stress and the strain-rate effects on the mechanical behaviour (plasticity and damage) of Ti-6Al-4 V alloy in metal cutting. In addition, Zorev contact model is used to simulate the contact stresses at both tool-chip and tool-workpiece interfaces. The proposed cutting model could predict relatively well the major cutting outcomes for seven cutting conditions. The difference between simulated and experimental cutting forces is less than 14%, but the predicted thrust force is underestimated about 53% in maximum. The difference between simulated and measured maximum compressive residual stresses in cutting and transversal directions can reach in average about 17% and 36%, respectively. The maximum difference between predicted and measured thicknesses of the layer affected by residual stresses is less than 19%. This study highlights several critical points affecting the thrust force and the residual stress predictions, which should be considered in future developments of cutting models.

Numerical simulation on surface residual stress for titanium alloy

Influence of Tool Geometrical Parameters on High Speed Cutting of Titanium Alloy Ti6Al4V

Simulation Study on Residual Stress Distribution of Machined Surface Layer in Two-Step Cutting of Titanium Alloy

Three-dimensional numerical simulation for high speed milling of aerospace aluminum alloy

Numerical investigations on residual stresses in orthogonal cutting of Ti-6A1-4V

Study on the Effect of Tool Inclination Angle in Machining Process Based on Three-Dimensional Thermo-Elastic-Plastic Model

Finite Element Analysis of Adiabatic Shear Band Formation in Titanium Alloy Cutting Process

Influence of cutting velocity on surface roughness during the ultra-precision cutting of titanium alloys based on a comparison between simulation and experiment

Machining mechanism and stress model in cutting Ti6Al4V

Simulation and Study on Surface Residual Stress Influence of TC4 Titanium Alloy

Modelling orthogonal cutting of Ti-6Al-4 V titanium alloy using a constitutive model considering the state of stress

Study on Numerical Simulation and Experiment of Titanium Alloy for High Speed Milling

The Role of Material Model in the Finite Element Simulation of High-Speed Machining of Ti6Al4V

Computational investigation on the surface cutting of γ-TiAl alloy

Study on the Orthogonal Cutting Process of Al7050T7451 with Uncoated and Coated Tools

Fe Analysis of the Effects of Cutting Speed on Thermomechanical Responses of Aisi 4142 Steel in High Speed Cutting

Finite element simulation of residual stress in machining of Ti-6Al-4V with a microstructural consideration

Modelling and Optimization of Machining of Ti-6Al-4V Titanium Alloy Using Machine Learning and Design of Experiments Methods

Experimental study on surface residual stress of titanium alloy curved thin-walled parts by ultrasonic longitudinal-torsional composite milling

Predicting Surface Residual Stress for Multi-Axis Milling of Ti-6Al-4V Titanium Alloy in Combined Simulation and Experiments

Numerical investigation of sequential cuts residual stress considering tool edge radius in machining of AISI 304 stainless steel