Abstract:In this study the effect of the cutting speed and an instantaneous heating source directly before cutting tool on the cutting force, cutting zones temperatures chip morphology, shear plane angle and strain rate during dry machining of Ti6Al4V. A 2D numerical model simulating orthogonal cutting process is created using Abaqus/Explicit software. In this model, Johnson Cook constitutive model is used to describe the material behavior during cutting process. Also, Johnson Cook damage model is used to simulation chip separation mechanism. After the verification of the model by comparison with results found in the literature, a number of simulations were run at different levels of four factors: cutting speed (40, 60, 80, 100, 120 and140m/min), heat source temperature (200, 400 and 600°C), heating source distance from the cutting tool (0.3, 0.6 and 0.9mm) and heating source size/diameter (0.6, 0.8 and 1mm). Taguchi L18 orthogonal mixed level design is used to plan for simulation runs using Minitab software. ANOVA analysis is used to investigate the significance of the four factors. The response table of means and the main effect of means is used to compare between the four factors and find their ranking. Based on 95% confidence Interval (CI), the results show that cutting speed has a significant effect on cutting force, strain rate, chip compression ratio, cutting tool nose temperature, cutting tool and chip temperature in the secondary deformation zone, average chip thickness at peaks and average chip thickness at valleys and average pitch. This conclusion is based on the P-values which are << 0.05 and the contribution which reaches 99.01%. Similarly, based on P-values < 0.05 and relatively high contribution reaches 12.16%, the heating source temperature has a significant effect on average chip thickness at valleys, chip compression ratio and strain rate. The cutting speed has Rank 1 among the four factors affecting cutting force, cutting zones temperatures, chip morphology, shear plane angel and stain rate. The effect of instantaneous heating directly before cutting process is negligible compared to the effect of plastic deformation and fracture mechanism in the cutting zone.

Fe Analysis of the Effects of Cutting Speed on Thermomechanical Responses of Aisi 4142 Steel in High Speed Cutting

Finite Element Simulation of High-Speed Cutting

Finite Element Simulation Of High-Speed Cutting Alloy Cast Iron

Simulation of High-Speed Milling Process of Aerospace Aluminum Alloy

Numerical simulation on surface residual stress for titanium alloy

Study on the Effect of Tool Inclination Angle in Machining Process Based on Three-Dimensional Thermo-Elastic-Plastic Model

Effect of cutting conditions on the serrated chip formation in high-speed cutting

Understanding The Deformation Of Metals In High Speed Cutting

The Role of Material Model in the Finite Element Simulation of High-Speed Machining of Ti6Al4V

The Effect of Cutting Speed on Residual Stresses when Orthogonal Cutting TC4

Simulation of the Cutting Sequence of AISI 316L Steel Based on the Smoothed Particle Hydrodynamics Method

Coupled Thermo-Mechanical Analysis of the High-Speed Hot-Forging Process

Finite Element Analysis of High Speed Cutting Tool

Study on the Orthogonal Cutting Process of Al7050T7451 with Uncoated and Coated Tools

Finite Element Modeling of High-Speed Milling 7050-T7451 Alloys

Predicting The High Speed Cutting Process Of Titanium Alloy By Finite Element Method

Finite Element Simulation of Cutting Temperature Field during High Speed Machining Hardened Steel Based on ABAQUS

The 3-D simulation of temperature fields with FEA in high speed cutting

A Novel Finite Element Model for Thermally Induced Machining of Ti6Al4V

Ti 6al 4V High-Speed Cutting Process Experiment and Finite Element Analysis

Finite Element Simulation and Experiment of Chip Formation During High Speed Cutting of Hardened Steel