Abstract:Friction significantly influences chip formation, thereby highlighting its modeling critical in numerical cutting simulations. Notably, issues like the underestimation of feed force in simulations are often attributed to inadequate friction models. Nevertheless, diverse conclusions in the literature regarding friction's behavior complicate the accurate implementation of this input. Additionally, the enormous of the available friction models and their varied calibration methods introduce further debates over which aspects of friction modeling should receive more focus. These controversies and deficiencies hinder progress in further understanding friction's role in chip formation through numerical studies. Instead of proposing or calibrating new friction models, the current study, based on Ti6Al4V machining simulations, attempts to readdress the aforementioned controversies in a neutral stance by conducting sensitivity studies using a hybrid Smoothed Particle Hydrodynamics (SPH) - Finite Element Method (FEM) solver with Graphics Processing Units (GPU) acceleration, which is capable of efficiently executing high-resolution computations. The significant impact of friction particularly at the end of the tool-chip contact on the chip formation, physical contact states and process forces are highlighted. The behaviors of physical parameters including normal contact pressure, sliding velocity, and temperature-dependent friction models in the literature are also evaluated. Several aspects such as the shear flow stress limit, the relationship between friction and process forces, and the selection of different models are discussed. In conclusion, pragmatic recommendations for friction modeling and cutting simulation work are provided. On the one hand, the available complex physical parameter dependent friction models could not prove their necessity and should be approached cautiously. Instead, the constant Coulomb friction model without the shear stress limit, despite its simplicity, demonstrates effective and sufficient for a single set of metal cutting simulations. On the other hand, reliable on-site measurement techniques of the coefficient of friction (COF) at the tool-chip sliding contact area should be developed, with consideration of the contact length and the state of material flow. Combined with careful cutting edge preparation and suitable constitutive models, the overall accuracy of numerical cutting simulations including the feed force prediction are expected to be improved.

Finite element simulation of cutting process under the worn tool edge geometries

Finite Element Simulation of High-Speed Cutting

Finite Element Simulation Of High-Speed Cutting Alloy Cast Iron

Effects of Tool Flank Wear on Orthogonal Cutting Process of Aluminum Alloy

The Finite Element Analysis Of Serrated Chip Formation In High-Speed Cuffing Auto Panel Dies

Finite Element Simulation of Serrated Chip Formation in High-speed Milling of A lloy Cast Iron

Coupled Thermo-mechanical Model for Metal Orthogonal Cutting Process and Finite Element Simulation

Finite element simulation and regression modeling of machining attributes on turning AISI 304 stainless steel

The Role of Material Model in the Finite Element Simulation of High-Speed Machining of Ti6Al4V

Fe Analysis of the Effects of Cutting Speed on Thermomechanical Responses of Aisi 4142 Steel in High Speed Cutting

Finite element based model for predicting induced residual stresses and cutting forces in AISI 1020 steel alloy

Finite Element Analysis of High Speed Cutting Tool

Generic Cutting Force Modeling Comprehensively Considering Tool Edge Radius, Tool Flank Wear and Tool Runout in Micro-End Milling

Investigation of friction modeling on numerical Ti6Al4V cutting simulations

Simulation and experimental study of tool wear in high-speed dry gear hobbing

Tool wear monitoring through online measured cutting force and cutting temperature during face milling Inconel 718

Prediction of cutting tool wear during a turning process using artificial intelligence techniques

Investigation of the tool flank wear influence on cutter-workpiece engagement and cutting force in micro milling processes

Three-dimensional turning force prediction based on hybrid finite element and predictive machining theory considering edge radius and nose radius

FEM mesh-dependence in cutting process simulations

A generic tool wear model and its application to force modeling and wear monitoring in high speed milling