Abstract:Titanium alloy materials are increasingly used in consumer products such as mobile phones and computers. Currently, manufacturers use ultra-high speed machining techniques to process titanium alloy materials to ensure high production efficiency. However, under the high spindle speed of 8000 rpm and a large feed rate of 4500 mm/min, the cutting speed of a 10 mm diameter milling tool reaches up to 251 m/min, which is significantly higher than the traditional cutting speed for titanium alloys (90 m/min). This ultra-high-speed cutting condition inevitably leads to a reduced tool life, consequently increasing manufacturing costs. Therefore, this paper focuses on studying methods to improve the cutting performance and tool life in titanium alloy ultra-high speed milling. First, failed milling tools on the titanium alloy processing production line were detected, and the failure modes and wear mechanisms of the tools under ultra-high speed milling conditions were analyzed. Based on this, a milling simulation model was established and calibrated through milling experiments. Then, simulation experiments were designed using the response surface methodology to reveal the impact of key tool geometric parameters on cutting performance, and the geometric parameters of the milling tool were optimized. Finally, based on the optimization results, milling tools were prepared and cutting performance and tool life experiments were conducted. Compared with the unoptimized milling tools, the optimized milling tools have significantly improved cutting performance and tool life, with cutting force reduced by 40 %–50 % and average tool life increased by 69.6 %.

Influence of Tool Geometrical Parameters on High Speed Cutting of Titanium Alloy Ti6Al4V

Three-dimensional numerical simulation for high speed milling of aerospace aluminum alloy

Numerical simulation on surface residual stress for titanium alloy

Study on the Effect of Tool Inclination Angle in Machining Process Based on Three-Dimensional Thermo-Elastic-Plastic Model

Surface Characteristics and Roughness Prediction of TC4 Titanium Alloy in High Speed Grinding

Research on 3D Numerical Simulation and Experiment of Cutting Temperature for High Speed Milling of Aerospace Aluminum Alloy

Mechanism of Saw-Tooth Chip Formation of Titanium Alloy Based on Finite Element Simulation

Effect of cutting conditions on the serrated chip formation in high-speed cutting

Study on the Orthogonal Cutting Process of Al7050T7451 with Uncoated and Coated Tools

Study on Numerical Simulation and Experiment of Titanium Alloy for High Speed Milling

Investigation of Cutting Force in High Feed Milling of Ti6al4v

A Simulation Study on the Effect of Micro-Textured Tools During Orthogonal Cutting of Titanium Alloy Ti-6Al-4V

Numerical Investigation on the Effect of Cutting-Edge Shape Factor on the Cutting Performance of Titanium Alloy

Research on cutting performance and tool life improvement methods of titanium alloy ultra-high speed milling tools

Molecular dynamics simulation of the effect of tool parameters on nano-cutting of polycrystalline γ-TiAl alloys

Influence of cutting velocity on surface roughness during the ultra-precision cutting of titanium alloys based on a comparison between simulation and experiment

The influence of the material behaviour law parameters and thermal properties on the chip morphology: application to the orthogonal cutting of Ti6Al4V alloy

Investigation on cutting forces and tool wear in high-speed milling of Ti-6Al-4V assisted by longitudinal torsional ultrasonic vibrations

Experimental Study on the Optimization of Ti1023 Milling Parameters

Analysis of the effect of tool geometry on the cutting process of polycrystalline Fe-Cr-W alloy based on molecular dynamics simulation

Study on Simulation and Experiment of Drilling for Titanium Alloys