Abstract:This paper aims to investigate the impact of various cutting parameters on the micro-cutting mechanism of high-entropy alloy FeCoCrNiAl0.6. It examines the cutting force, cutting temperature, and residual stress of FeCoCrNiAl0.6 high-entropy alloy micro-cutting using the finite element simulation method. The research findings reveal the following: as the cutting depth increases, the three-dimensional cutting force gradually rises, exhibiting a significant growth trend, and there is a positive correlation between them. Increasing the cutting speed results in small fluctuations in cutting force, which remains relatively stable. Moreover, the cutting force gradually increases with higher feed rates, demonstrating a positive correlation. The maximum temperatures of the tool surface and chip surface increase with higher cutting depth, and they are positively correlated. There is a positive correlation between cutting temperature and cutting speed. With increased cutting speed, the maximum temperature of the cutting surface steadily rises. Simultaneously, during cutting, the chip temperature increases at a faster rate compared to the tool temperature with increasing cutting speed. As the feed rate continuously increases, the maximum temperatures of the chip surface and tool surface show a steady growth trend, and there is a positive correlation between them. During the cutting process, the workpiece surface is predominantly characterized by residual compressive stress. Under different cutting depths, the absolute value of the maximum residual compressive stress on the workpiece surface decreases. Under the influence of cutting speed, when the cutting speed is below 110 mm/s, the residual compressive stress on the workpiece surface demonstrates an increasing trend. For cutting speeds between 110 and 170 mm/s, the workpiece surface initially exhibits a decreasing trend followed by an increasing trend. Increasing the feed rate leads to an increase in the absolute value of the maximum residual compressive stress on the workpiece surface.

Research on the effect of cutting parameters on the machinability of polycrystalline Fe-Cr-W alloy by molecular dynamics simulation

Molecular dynamics simulation of cutting mechanism of polycrystalline Fe-Cr-W alloy

Analysis of the effect of tool geometry on the cutting process of polycrystalline Fe-Cr-W alloy based on molecular dynamics simulation

Study on the Effect of Tool Inclination Angle in Machining Process Based on Three-Dimensional Thermo-Elastic-Plastic Model

Influence of Tool Geometrical Parameters on High Speed Cutting of Titanium Alloy Ti6Al4V

Finite Element Simulation Of High-Speed Cutting Alloy Cast Iron

Atomic simulation for the effect of nano-cutting parameters on the 3D surface morphology of polycrystalline γ-TiAl alloy

Molecular dynamics simulation of the effect of tool parameters on nano-cutting of polycrystalline γ-TiAl alloys

Molecular dynamics simulation of the influence of nanocutting parameters on microstructure of AISI M2

Effect of Workpiece Atom Diffusion Into CBN Tool on Its Mechanical Properties in Cutting Ni–Fe–Cr Alloy Based on Molecular Dynamics Simulation

Molecular Dynamics Simulation Study on the Influence of the Abrasive Flow Process on the Cutting of Iron-Carbon Alloys (α-Fe)

Effect of dislocation density distribution in work-hardened layer on cutting characteristics in the multi-cutting of 49Fe49Co2V alloy

Numerical simulation of nano-cutting behaviors for polycrystalline γ-TiAl alloy: The effect of grain sizes

Study on the Orthogonal Cutting Process of Al7050T7451 with Uncoated and Coated Tools

Effect of cutting conditions on the serrated chip formation in high-speed cutting

Wear mechanism of diamond-cutting tool in nano-cutting polycrystalline γ-TiAl alloy based on molecular dynamics simulation

Molecular dynamics simulation for temperature assisted machining of a polycrystalline γ-TiAl alloy

Influence of cutting parameters on PCD tool wear during milling tungsten carbide

Optimization of Machining Parameters for Milling Zirconia Ceramics by Polycrystalline Diamond Tool

Nanocutting mechanisms of Cu50Zr50 amorphous alloy: A molecular dynamics simulation

Investigation on the micromachining mechanism of FeCoCrNiAl0.6 high-entropy alloy