Abstract:For any gas or LNG plant, higher levels of nitrogen within your feed gas mean lower profitable volumes or additional capital investment. Nitrogen Removal Units (NRU) can be expensive to build and difficult to operate. The challenges facing the gas industry are highlighted by the Gas Technology Institute (GTI, USA) in their estimates that 11% of current daily gas production and 16% of all known gas reserves in the USA contain some nitrogen.Recent gas reservoir discoveries around the world were also found to contain significant levels of nitrogen up to the 15% range. Also, some current production techniques for maintaining crude recovery from a reservoir utilize the injection of nitrogen as enhanced oil recovery (EOR) method. Gradually and eventually, the equilibrium nitrogen dissolved in the crude will come to the surface as associated gas when the nitrogen breaks through.Gas companies typically set maximum concentration limits on nitrogen content in the pipeline between 4.0 and 7.0 percent depending on the local product specifications. Therefore, in general, nitrogen levels of greater than 7.0 percent must undergo removal.The author's focus in this paper is on the selection/design criteria to be considered for the selection of an optimum NRU technology.1) Feed gas nitrogen concentrations,2) NRU inlet pressure,3) NRU capacity,4) Product Specifications,5) Approaches for the final disposition of the recovered hydrocarbon stream: (e.g., as fuel gas, re-injection or recycle back to feed gas),6) Environmental NOx emissions impact,7) Allowable methane concentration in the nitrogen vent.The author summaries all currently available technologies including both commercially demonstrated NRU technologies as well as the future developments.All of those available technologies to be introduced by the author by way of process flow diagrams, descriptions, technology highlights, pre-treatment requirements, strength and weakness and technology licensor/vendor lists are:• Cryogenic Distillation,• Membranes (Membrane Technology and Research (MTR),• Molecular Gate System,• Solvent Absorption,• Nitrogen Sponge,• Pressure swing adsorption (PSA), Carbon Molecular Sieve (CMS),• Lean Oil Absorption,• Chelating chemical.

Economic assessment of a natural gas upgrading process using pressure vacuum swing adsorption for nitrogen removal

Separation of Methane–Nitrogen Mixture by Pressure Swing Adsorption for Natural Gas Upgrading

Methane/nitrogen separation through pressure swing adsorption process from nitrogen-rich streams

Techno-economic analysis of vacuum pressure swing adsorption process for a sustainable upgrading of biogas

Pros and cons of different Nitrogen Removal Unit (NRU) technology

An improved vacuum pressure swing adsorption process with the simulated moving bed operation mode for CH4/N2 separation to produce high-purity methane

Nitrogen rejection from natural gas by dual reflux-pressure swing adsorption using activated carbon and ionic liquidic zeolite

Multiscale design of a pressure swing adsorption process for natural gas purification

Natural Gas Sweetening Using an Energy-Efficient, State-of-the-Art, Solid–Vapor Separation Process

Nitrogen rejection from low quality natural gas by pressure swing adsorption experiments and simulation using dynamic adsorption isotherms

The removal of CO2 and N2 from natural gas: A review of conventional and emerging process technologies

Methane Recovery from Low-Grade Unconventional Natural Gas by the Integrated Mode of the Conventional/improved Vacuum Pressure Swing Adsorption Processes

Biomethane production by adsorption technology: new cycle development, adsorbent selection and process optimization

Optimization of a Six-Step Pressure Swing Adsorption Process for Biogas Separation on a Commercial Scale

Development of Natural Gas Liquefaction Processes Using Mixed Refrigerants: a Review of Featured Process Configurations and Performance

Purification of helium from a cryogenic natural gas nitrogen rejection unit by pressure swing adsorption

High sour natural gas dehydration treatment through low temperature technique: Process simulation, modeling and optimization

Natural gas treating by selective adsorption: Material science and chemical engineering interplay

Nitrogen replacement strategy to efficiently enhance methane recovery of the methane purification process using nitrogen equilibrium selective sorbent

Simulation of Natural Gas Treatment for Acid Gas Removal Using the Ternary Blend of MDEA, AEEA, and NMP

Separation of Methane and Nitrogen Using Heavy Reflux Pressure Swing Adsorption: Experiments and Modeling