Magnetic and structural behaviours of nanocrystalline Fe 70.8 Nb 3.7 Cu 1 Al 2.7 Mn 0.7 Si 13.5 B 7.6 alloy

A. Mitra,A. K. Panda,S. R. Singh,V. Rao,P. Ramachandrarao
DOI: https://doi.org/10.1080/014186103100004609
2003-01-01
Abstract:The crystallization behaviour of Fe 70.8 Nb 3.7 Cu 1 Al 2.7 Mn 0.7 Si 13.5 B 7.6 alloy prepared in the form of amorphous ribbons by melt-spinning technique was studied using differential scanning calorimetry and the temperature variation in resistivity. An X-ray diffaction and transmission electron microscopy study showed the formation of f-Fe(Si, Al) and/or Fe 3 (Si, Al) nanoparticles after the first stage of crystallization. The activation energy for this nanophase formation was 68 kcal mol m1 . The brittleness of the alloy increased with the formation of nanoparticles after heat treatment. Superior soft magnetic properties were achieved when the material was heat treated at 790 K for 15 min. The particle size at the optimum heat treatment condition for superior soft magnetic properties was found to be 6.0 -0.5 nm which was less compared than for the Fe-Nb-Cu-Si-B system. The observed coercivity value at the optimum heat treatment condition was found to be 0.32 A m m1 (approximately 4 mOe). The presence of Al in the alloy reduced the particle size and the magnetic anisotropy energy of the system, which resulted in superior soft magnetic properties of the heat-treated materials.
materials science, multidisciplinary,physics, applied, condensed matter,metallurgy & metallurgical engineering
What problem does this paper attempt to address?
The problem that this paper attempts to solve is to improve the soft magnetic properties of nanocrystalline alloys by adding aluminum (Al) and a small amount of manganese (Mn) in the Fe - Nb - Cu - Si - B alloy system. Specifically, the researchers hope to reduce the size of nanoparticles and the magnetocrystalline anisotropy energy of the system by adjusting the alloy composition, especially by adding Al and Mn, so as to achieve superior soft magnetic properties, such as lower coercivity and higher permeability. In addition, the study also explored the changes in the structure, magnetic and mechanical behaviors of these alloys under different heat - treatment conditions in order to find the optimal heat - treatment conditions to optimize the soft magnetic properties of the materials.