Abstract:In the present study, we analyse the mechanical structure for the two-stage anvil cell, and design the two-stage high pressure cell using diamond-cemented carbide compound as anvil-material. The diamond-cemented carbide compound material is synthesized using the 6 × 2500 ton cubic press in our laboratory. We sinter diamond/Co layer (Φ30 mm×10 mm) on a WC-cobalt substrate (Φ30 mm×13 mm) at high pressures and temperatures, then, we obtain the cubic anvils from the sintered cylindrical chunks by wire-electrode cutting. The diamond-cemented carbide compound anvil has three advantages over the traditional sintered diamond anvil:first, a scaled-up version of the sintered diamond anvil could be obtained by sintering the diamond/Co layer on a WC-cobalt substrate;second, the diamond-cemented carbide compound anvil is machined easily compared with the sintered diamond anvil;and third, the experimental cost using the diamond-cemented carbide compound anvils is much lower than using the sintered diamond anvil. Using the diamond-cemented carbide compound anvil, we design the two-stage 5.5/1.5 (octahedral edge-length/anvil truncation edge-length, in millimetre) assemble. Pressure calibration at room temperature is performed for the 5.5/1.5 assemble using the phase transitions of Zr (α-ω, 7.96 GPa;ω-β, 34.5 GPa) under high pressures. The pressure range of the two-stage apparatus besed on hinge-type cubic press is extended from 20 GPa to about 35 GPa using the 5.5/1.5 assemble. The pressure calibration for the two-stage apparatus using diamond-cemented carbide compound anvil is ongoing in our laboratory. We believe that the pressures above 50 GPa could be achieved using these anvils.

Electroplated mounting of diamond anvils for use in cryogenic systems

Calibration of Pressure to 35 Gpa for the Cubic Press Using the Diamond-Cemented Carbide Compound Anvil

Composite Chemical Vapor Deposition Diamond Anvils for High-Pressure/high-temperature Experiments

A diamond anvil microassembly for Joule heating and electrical measurements up to 150 GPa and 4000 K

A miniature multi-anvil apparatus using diamond as anvils—MDAC: Multi-axis diamond anvil cell

New diamond cell for single-crystal x-ray diffraction

Micro- and Nanostructured Diamond in Electrochemistry: Fabrication and Application

Recent Design of Ultrahigh-Pressure Diamond Cell

A new type of hydrothermal diamond-anvil cell with cooling system

Diamond coatings on copper surfaces through interface engineering

Electroless Deposition of Copper and Fabrication of Copper Micropatterns on CVD Diamond Film Surfaces

A Diamond Gasket for the Laser-Heated Diamond Anvil Cell

Sample heating above 1400 K in a diamond anvil cell

Coupling High Hardness and Zn Affinity in Amorphous-Crystalline Diamond for Stable Zn Metal Anodes

Leveraging oxide reactive sputtering for thermal insulation in laser-heated diamond anvil cell

High Pressure High Temperature Synthesis of Highly Boron Doped Diamond Microparticles and Porous Electrodes for Electrochemical Applications

Optimization of External and Internal Conditions for High Thermal Conductive Cu-diamond Composites Produced by Electroplating

Development of All-Diamond Scanning Probes Based on Faraday Cage Angled Etching Techniques

Facile electroless copper plating on diamond particles without conventional sensitization and activation

Rapid Growth of Nanocrystalline Diamond on Single Crystal Diamond for Studies on Materials under Extreme Conditions