Abstract:Ga2O3 has attracted great attention for electronic device applications due to its ultra-wide bandgap, high breakdown electric field, and large-area affordable substrates grown from the melt. However, its thermal conductivity is significantly lower than that of other wide bandgap semiconductors, which will impact its ability to be used in high power density applications. Thermal management in Ga2O3 electronics will be the key for device reliability, especially for high power and high frequency devices. Similar to the method of cooling GaN-based high electron mobility transistors by integrating it with high thermal conductivity diamond substrates, this work studies the possibility of heterogeneous integration of Ga2O3 with diamond for thermal management of Ga2O3 devices. In this work, Ga2O3 was deposited onto single crystal diamond substrates by ALD and the thermal properties of ALD-Ga2O3 thin films and Ga2O3-diamond interfaces with different interface pretreatments were measured by TDTR. We observed very low thermal conductivity of these Ga2O3 thin films due to the extensive phonon grain boundary scattering resulting from the nanocrystalline nature of the Ga2O3 film. However, the measured thermal boundary conductance (TBC) of the Ga2O3-diamond interfaces are about 10 times larger than that of the Van der Waals bonded Ga2O3 diamond interfaces, which indicates the significant impact of interface bonding on TBC. Furthermore, the TBC of the Ga-rich and O-rich Ga2O3-diamond interfaces are about 20% smaller than that of the clean interface, indicating interface chemistry affects interfacial thermal transport. Overall, this study shows that a high TBC can be obtained from strong interfacial bonds across Ga2O3-diamond interfaces, providing a promising route to improving the heat dissipation from Ga2O3 devices.

Leveraging oxide reactive sputtering for thermal insulation in laser-heated diamond anvil cell

A Diamond Gasket for the Laser-Heated Diamond Anvil Cell

Laser heating setup for diamond anvil cells for in situ synchrotron and in house high and ultra-high pressure studies

A diamond anvil microassembly for Joule heating and electrical measurements up to 150 GPa and 4000 K

Heteroepitaxial growth of diamond films on Y3Al5O12 single crystals

In Situ Raman Spectroscopy with Laser-Heated Diamond Anvil Cells

Deposition of Tungsten-Doped V2O5 Thin Films on Non-Alkali Glass Substrate by RF Magnetron Sputtering for Thermal Insulation

Composite Chemical Vapor Deposition Diamond Anvils for High-Pressure/high-temperature Experiments

Sample heating above 1400 K in a diamond anvil cell

Atomic layer deposition of Al2O3 and HfO2 for high power laser application

Integration of Atomic Layer Epitaxy Crystalline Ga2O3 on Diamond for Thermal Management

C+ ion implanted single crystal diamond with amorphous surface for efficient oxygen evolution catalysis

Diamond anvil cell with boron-doped diamond heater for high-pressure synthesis and in-situ transport measurements

Cryogenic assisted femtosecond laser ablation of polycrystalline diamond

Numerical Study of Thermal Shock on Infrared Windows and Their Composites with Diamond Coatings under Harsh Conditions

Dielectric Performance of Oxidation Ceramic Coating for High Temperature Insulation

X-Ray Diffraction And Laser Heating: Application Of A Moissanite Anvil Cell

Crystalline Flat Surface Recovered by High-Temperature Annealing after Laser Ablation

In situ measurement techniques using diamond anvil cell at high pressure–temperature conditions: A review

Near-infrared focused heating method for the rotational diamond anvil cell