Abstract:In the present study, we analyse the mechanical structure for the two-stage anvil cell, and design the two-stage high pressure cell using diamond-cemented carbide compound as anvil-material. The diamond-cemented carbide compound material is synthesized using the 6 × 2500 ton cubic press in our laboratory. We sinter diamond/Co layer (Φ30 mm×10 mm) on a WC-cobalt substrate (Φ30 mm×13 mm) at high pressures and temperatures, then, we obtain the cubic anvils from the sintered cylindrical chunks by wire-electrode cutting. The diamond-cemented carbide compound anvil has three advantages over the traditional sintered diamond anvil:first, a scaled-up version of the sintered diamond anvil could be obtained by sintering the diamond/Co layer on a WC-cobalt substrate;second, the diamond-cemented carbide compound anvil is machined easily compared with the sintered diamond anvil;and third, the experimental cost using the diamond-cemented carbide compound anvils is much lower than using the sintered diamond anvil. Using the diamond-cemented carbide compound anvil, we design the two-stage 5.5/1.5 (octahedral edge-length/anvil truncation edge-length, in millimetre) assemble. Pressure calibration at room temperature is performed for the 5.5/1.5 assemble using the phase transitions of Zr (α-ω, 7.96 GPa;ω-β, 34.5 GPa) under high pressures. The pressure range of the two-stage apparatus besed on hinge-type cubic press is extended from 20 GPa to about 35 GPa using the 5.5/1.5 assemble. The pressure calibration for the two-stage apparatus using diamond-cemented carbide compound anvil is ongoing in our laboratory. We believe that the pressures above 50 GPa could be achieved using these anvils.

Composite Chemical Vapor Deposition Diamond Anvils for High-Pressure/high-temperature Experiments

Calibration of Pressure to 35 Gpa for the Cubic Press Using the Diamond-Cemented Carbide Compound Anvil

Generation Of Ultrahigh Pressure Using Single-Crystal Chemical-Vapor-Deposition Diamond Anvils

A miniature multi-anvil apparatus using diamond as anvils—MDAC: Multi-axis diamond anvil cell

The moissanite anvil cell: a new tool for high-pressure research

A Diamond Gasket for the Laser-Heated Diamond Anvil Cell

Diamond Anvil Cell Behavior Up to 4 Mbar

Recent Design of Ultrahigh-Pressure Diamond Cell

New diamond cell for single-crystal x-ray diffraction

Sample heating above 1400 K in a diamond anvil cell

In situ measurement techniques using diamond anvil cell at high pressure–temperature conditions: A review

A diamond anvil microassembly for Joule heating and electrical measurements up to 150 GPa and 4000 K

Electroplated mounting of diamond anvils for use in cryogenic systems

Extreme static compression of carbon to terapascal pressures

Raman Spectra Based Pressure Calibration of the Non-Gauge Sapphire Anvil Cell at High Temperature and High Pressure

Application of a New Composite Cubic-Boron Nitride Gasket Assembly for High Pressure Inelastic X-Ray Scattering Studies of Carbon Related Materials.

Study of Diamond Anvil Cell for In-Situ High-temperature and High-pressure Spectrum

Numerical Parameterization of Chemical-Vapor-Deposited (CVD) Single-Crystal Diamond for Device Simulation and Analysis

The Gem Anvil Cell: High-Pressure Behaviour of Diamond and Related Materials

Fracture Strength and Toughness of Chemical-Vapor-deposited Polycrystalline Diamond Films