Abstract:In the present study, we analyse the mechanical structure for the two-stage anvil cell, and design the two-stage high pressure cell using diamond-cemented carbide compound as anvil-material. The diamond-cemented carbide compound material is synthesized using the 6 × 2500 ton cubic press in our laboratory. We sinter diamond/Co layer (Φ30 mm×10 mm) on a WC-cobalt substrate (Φ30 mm×13 mm) at high pressures and temperatures, then, we obtain the cubic anvils from the sintered cylindrical chunks by wire-electrode cutting. The diamond-cemented carbide compound anvil has three advantages over the traditional sintered diamond anvil:first, a scaled-up version of the sintered diamond anvil could be obtained by sintering the diamond/Co layer on a WC-cobalt substrate;second, the diamond-cemented carbide compound anvil is machined easily compared with the sintered diamond anvil;and third, the experimental cost using the diamond-cemented carbide compound anvils is much lower than using the sintered diamond anvil. Using the diamond-cemented carbide compound anvil, we design the two-stage 5.5/1.5 (octahedral edge-length/anvil truncation edge-length, in millimetre) assemble. Pressure calibration at room temperature is performed for the 5.5/1.5 assemble using the phase transitions of Zr (α-ω, 7.96 GPa;ω-β, 34.5 GPa) under high pressures. The pressure range of the two-stage apparatus besed on hinge-type cubic press is extended from 20 GPa to about 35 GPa using the 5.5/1.5 assemble. The pressure calibration for the two-stage apparatus using diamond-cemented carbide compound anvil is ongoing in our laboratory. We believe that the pressures above 50 GPa could be achieved using these anvils.

New diamond cell for single-crystal x-ray diffraction

Calibration of Pressure to 35 Gpa for the Cubic Press Using the Diamond-Cemented Carbide Compound Anvil

Recent Design of Ultrahigh-Pressure Diamond Cell

50‐kilobar gasketed diamond anvil cell for single‐crystal x‐ray diffractometer use with the crystal structure of Sb up to 26 kilobars as a test problem

A Diamond Gasket for the Laser-Heated Diamond Anvil Cell

A nano-polycrystalline diamond anvil cell with bulk metallic glass cylinder for single-crystal neutron diffraction

Large-volume diamond cells for neutron diffraction above 90 GPa

A Focusing System for X-ray Diffraction Studies of Materials under High Pressure in the Diamond Cell

Diamond Anvil Cell Behavior Up to 4 Mbar

A miniature multi-anvil apparatus using diamond as anvils—MDAC: Multi-axis diamond anvil cell

Use of a confocal optical device for centring a diamond anvil cell in single‐crystal X‐ray diffraction experiments

Ultrahigh-pressure Experiment with a Motor-Driven Diamond Anvil Cell.

The moissanite anvil cell: a new tool for high-pressure research

X-Ray Imaging Of Stress And Strain Of Diamond, Iron, And Tungsten At Megabar Pressures

Composite Chemical Vapor Deposition Diamond Anvils for High-Pressure/high-temperature Experiments

New dynamic diamond anvil cell for time-resolved radial x-ray diffraction

Energy dispersive x-ray diffraction of micro-crystals at ultrahigh pressures

Suppression of Bragg Reflection Glitches of a Single-Crystal Diamond Anvil Cell by a Polycapillary Half-Lens in High-Pressure XAFS Spectroscopy.

A System for Doing Low Temperature-High Pressure Single Crystal X-ray Diffraction with a Synchrotron Source

Amorphous Boron Gasket in Diamond Anvil Cell Research

A new compact symmetric rotational diamond anvil cell for in situ high-pressure-torsion studies