Behavior of Coated Carbide Tools in High Speed Machining of a Nickel Base Alloy

E. O. Ezugwu,C. I. Okeke

DOI: https://doi.org/10.1080/10402000208982530

IF: 2.056

2002-01-01

Tribology Transactions

Abstract:Multilayer TiN/TiCN/TiN and single-layer TiAIN PVD coated carbide tools were used to machine a nickel base, C-263, alloy at high-speed conditions in order to investigate their performance in terms of tool life, surface finish and component forces generated during machining. The test results show that the triple layer, TiN/TiCN/TiN, coated inserts gave longer tool life when machining at higher speed and depth of cut conditions while the single layer, TiA/N, coated inserts produced better surface finish. The feed forces recorded were generally higher than the cutting forces. This could perhaps be attributed to the adverse effect of burr formation and work hardening of the workpiece associated with prolonged machining. Analysis of the test results indicate that the difference in thermal properties and tribo-chemical behaviour of both the coating and substrate materials are the major factors influencing the tribo-contact at the tool-chip interface during machining. Wear mechanisms of the coating materials can also affect tool performance in terms of tool life, surface finish and component forces. Presented as a Society of Tribologists and Lubrication Engineers Paper at the STLE/ASME Tribology Conference in San Francisco, CA October 21–24, 2001 Presented as a Society of Tribologists and Lubrication Engineers Paper at the STLE/ASME Tribology Conference in San Francisco, CA October 21–24, 2001

engineering, mechanical