Abstract:Vat photopolymerization-based additive manufacturing is a promising technology for the preparation of ceramic parts, owing to its short fabrication cycle and low manufacturing cost. However, its application is limited due to the low mechanical properties and deformation of ceramic parts. To improve the properties of ceramic parts, changing particle size and printing parameters have been found to be useful. Herein, alumina ceramic parts were prepared using three different powders with different particle size (Powder A: D 50 = 1.3 μm, D 90 = 6.1 μm; Powder B: D 50 = 3.4 μm, D 90 = 10.0 μm; Powder C: D 50 = 1.3 μm, D 90 = 2.8 μm), different layer thickness (50 μm, 75 μm, 100 μm), and different curing times (1 s, 3 s, 5 s, 8 s). The ceramics prepared with Powder A and Powder C, which possessed the same D 50 , had almost the same flexural strength, indicating that the flexural strength is closely related to the particle size and its distribution. With the increase in layer thickness, the flexural strength was increased. When the layer thickness was 100 μm, the flexural strength reached 18.5 MPa when samples were prepared with Powder A and Powder C. At the same time, the flexural strength firstly increased and subsequently decreased with increasing curing time. Based on the flexural strength and shrinkage of the sintered ceramics, using Powder A, layer thickness of 50 μm, and curing time of 5 s were regarded as the best fabrication conditions. The results indicate that adjusting powder particle size distribution, layer thickness, and curing time are promising methods for the fabrication of 3D printed ceramics with optimized properties.

Preparation and Mechanical Property of Alumina Fibers Reinforced Thin Architectural Ceramic Plate

Preparation of Fly Ash-Based Porous Ceramic with Alumina as the Pore-Forming Agent

Cellular arrays of alumina fibres

The Effects of Mineral Composition and Sintering Temperature on Synthetic Mullite

Fabrication of Homogeneous Mullite-Based Fiber Porous Ceramics with High Strength and Porosity

Effect of Alumina Fiber Content on Pore Structure and Properties of Porous Ceramics

Fabrication of alumina ceramics with high flexural strength using stereolithography

Preparation of Porous Ceramic Materials by Alumina Fiber Framework

Microstructures and mechanical properties of additively manufactured alumina ceramics with digital light processing

SiC Nanoparticles Strengthened Alumina Ceramics Prepared by Extrusion Printing

Strengthening Effect of Short Carbon Fiber Content and Length on Mechanical Properties of Extrusion-Based Printed Alumina Ceramics

Microstructure and Mechanical Properties of an Alumina–glass Low Temperature Co-Fired Ceramic

Effect of different sintering additives type on Vat photopolymerization 3D printing of Al2O3 ceramics

Preparation and research of fine-grained alumina with high mechanical properties

Zirconia-alumina multiphase ceramic fibers with exceptional thermal stability by melt-spinning from solid ceramic precursor

Effects of sintering temperature on mechanical properties of alumina fiber reinforced alumina matrix composites

Effect of thermal exposure on the microstructure and strength of an alumina‐silica ceramic fiber

Effect of particle size distribution and printing parameters on alumina ceramics prepared by Additive Manufacturing

Al 2 O 3 -fiber-reinforced porous YSZ ceramics with high mechanical strength

Effect of interfacial Fe3O4 nanoparticles on the microstructure and mechanical properties of textured alumina densified by ultrafast high-temperature sintering

The Mechanical Properties of Glass Infiltrated Alumina Ceramics