Abstract:Alumina (Al2O3) ceramics are widely used in electronics, machinery, healthcare, and other fields due to their excellent hardness and high temperature stability. However, their high brittleness limits further applications, such as artificial ceramic implants and highly flexible protective gear. To address the limitations of single-phase toughening in Al2O3 ceramics, some researchers have introduced a second phase to enhance these ceramics. However, introducing a single phase still limits the range of performance improvement. Therefore, this study explores the printing of Al2O3 ceramics by adding two different phases. Additionally, a new gradient printing technique is proposed to overcome the limitations of single material homogeneity, such as uniform performance and the presence of large residual stresses. Unlike traditional vat photopolymerization printing technology, this study stands out by generating green bodies with varying second-phase particle ratios across different layers. This study investigated the effects of different contents of sepiolite fiber (SF) and 316L stainless steel (SS) on various aspects of microstructure, phase composition, physical properties, and mechanical properties of gradient-printed Al2O3. The experimental results demonstrate that compared to Al2O3 parts without added SF and 316L SS, the inclusion of these materials can significantly reduce porosity and water absorption, resulting in a denser structure. In addition, the substantial improvements, with an increase of 394.4% in flexural strength and an increase of 316.7% in toughness, of the Al2O3 components enhanced by incorporating SF and 316L SS have been obtained.

Strengthening Effect of Short Carbon Fiber Content and Length on Mechanical Properties of Extrusion-Based Printed Alumina Ceramics

SiC Nanoparticles Strengthened Alumina Ceramics Prepared by Extrusion Printing

Effect of particle size distribution and printing parameters on alumina ceramics prepared by Additive Manufacturing

Enhanced mechanical properties of 3D printed alumina ceramics by using sintering aids

Microstructure and Mechanical Properties of Porous Alumina Ceramic Prepared by a Combination of 3–D Printing and Sintering

Influence of infill patterns on mechanical properties of 3D printed Al2O3 ceramics via fused filament fabrication

Additive manufacturing of fiber reinforced zirconia‐toughened alumina (ZTA) ceramic matrix composites (CMC) by material extrusion‐based technology

Enhanced 3D Printed Alumina Ceramic Cores Via Impregnation

Preparation and Mechanical Property of Alumina Fibers Reinforced Thin Architectural Ceramic Plate

Fabrication of alumina ceramics with high flexural strength using stereolithography

Optimization of 3D Printing Parameters for Alumina Ceramic Based on the Orthogonal Test

Effect Of Alumina-Based Fiber On The Mid-Temperature Strength Of Integral Ceramic Mold For Casting Hollow Turbine Blade

Ceramic composites toughened by vat photopolymerization 3D printing technology

Influence of debinding holding time on mechanical properties of 3D-printed alumina ceramic cores

Effect of different sintering additives type on Vat photopolymerization 3D printing of Al2O3 ceramics

Dynamic mechanical properties of Alumina prepared by vat photopolymerization based on high solid loading slurry

Vat Photopolymerization of Ceramic Parts: Effects of Carbon Fiber Additives on Microstructure and Mechanical Performance

Microstructure and mechanical properties of 3D printed porous Al2O3–ZrO2 laminated ceramics with tailored porosity

Effect of Holding Time During Sintering on Microstructure and Properties of 3D Printed Alumina Ceramics

Vat Photopolymerization of Sepiolite Fiber and 316L Stainless Steel-Reinforced Alumina with Functionally Graded Structures

Effect of Alumina Fiber Content on Pore Structure and Properties of Porous Ceramics