Abstract:EPB shield tunnel construction will discharge a large amount of soil. Directly transporting this discharged soil to dumping grounds not only increases the machinery and labor costs but also raises environmental concerns. In this paper, we presented and explored a guiding framework for recycling the discharged soil from EPB shield tunnel construction as the raw materials for synchronous grouting. The proposed method was proved to be feasible by a detailed experimental study based on samples taking from the Zhengzhou metro line 3 project. The preparation and formulation process of those raw materials was designed to meet the requirements not only for engineering application but also for green environmental protection and sustainable development. The properties and performance of the synchronous grouting material, including its specific gravity, fluidity, gel time, bleeding rate, bulk shrinkage rate and unconfined compression strength, were investigated by the U15* (154) uniform design experimentation. The effects of ratios of water/binder (cement + fly flash), the binder/coarse-grains (the discharged soil from the west bound tunnel + river sand), fine-grains (the discharged soil from the east bound tunnel)/water and the fly flash/cement on the response value of the synchronous grouting material performances have been investigated with stepwise nonlinear regression analysis model and 3D response surface diagrams. Moreover, the optimal mass ratio for the synchronous grout is also proposed with a new Goal Programming model to obtain an optimum performance. The results indicate that the discharged soil from the east bound tunnel in this project can be directly reused as bentonite, while the discharged soil from the west bound tunnel should be mixed with river sand at a mass ratio of 1:1 before reusing it as the raw material of synchronous grout. Furthermore, the performance of the synchronous grouting was demonstrated highly depending on the proper selection and optimization of mass ratios for water/binder, binder/coarse-grains, fine-grains/water and fly-ash/cement. The presented experimental investigation and the proposed strategy for determining the optimal formulation for synchronous grouting materials demonstrated a feasible way of recycling discharged soil from EPB shield tunnel construction.

Experimental Study on Fresh State Properties of Single-Liquid Semi-Inert Synchronous Grouting for Shield Tunnels in Water-Rich Sand Strata

STUDY OF GROUND HEAVE AND SUBSIDENCE INDUCED BY SHIELD TUNNELLING IN SOFT GROUND

Sedimentation-affected Engineering Performances and Microstructures of a Hybrid Portland- Sulfate Aluminate Cement Grout Cast in Long Tubes

Experimental study of the direct shear characteristics of cement grout under constant normal loading and stiffness boundary conditions

Study on the shear strength characteristics and source mechanism of early-age shield synchronous grouting materials

Influence of synchronous grouting on surrounding sandy cobbles during shield tunnelling process: Insights from a scaled model test

Study on the Floating of Large Diameter Underwater Shield Tunnel Caused by Synchronous Grouting

Experimental Study of High Performance Synchronous Grouting Materials Prepared with Clay

Research and evaluation on Water-dispersion resistance of synchronous grouting slurry in shield tunnel

Research on synchronous grouting mixing proportion of saturated sand stratum shield tunnel

Shield method tunnel synchronous grouting slurry applied to compound stratum with upper soft part and lower hard part

A literature review on properties and applications of grouts for shield tunnel

A computational method proposal on the determination of grouting parameters for shield construction in water-rich earth materials

Experimental Study on Shield Tunneling Control in Full Section Water-Rich Sand Layer of Collapsible Loess

Application of geopolymer in synchronous grouting for reusing of the shield muck in silty clay layer

Recycling of discharged soil from EPB shield tunnels as a sustainable raw material for synchronous grouting

Application of a novel grouting material for prereinforcement of shield tunnelling adjacent to existing piles in a soft soil area

Study on the Influence of Back-fill Grouting Parameters in Unsaturated Strata on the Seismic Performance of Shield Tunnels

Advanced Grouting Model and Influencing Factors Analysis of Tunnels with High Stress and Broken Surrounding Rock

Grout Diffusion in Silty Fine Sand Stratum with High Groundwater Level for Tunnel Construction

In situ resource reutilization of earth pressure balance (EPB) shield muck for the generation of novel synchronous grouting materials