Abstract:Abstract Background In recent years, the technology of blocking and grouting of has been widely used in the treatment of groundwater inrush in tunnels in China’s mines. Studies have been carried out on the aggregates pouring under hydrodynamic conditions; however, there is lack of studies of the grout propagation in the pouring aggregate mass, which formed in the earlier stage. This paper presents an experimental investigation of grout propagation in poured aggregates with flowing water, which focused on the second stage, i.e., the grouting stage, after the first stage of aggregates pouring in the salvage of an inundated underground tunnel. Results In this work, a visualized tunnel replica with flowing water was adopted to investigate the main effects of sealing efficiency, water pressure variation, propagation mechanism during grouting in the poured aggregates with different grain sizes and flowing water conditions. A series of experiments with orthogonal array design were carried out, and the propagation of cement/sodium silicate and the change characteristics of fluid pressure in the tunnel were obtained. The results show that the main effects on the sealing efficiency of grouting in poured aggregates with flowing water in a descending order is cement/sodium silicate ratio, relative density of aggregates, particle size distribution of aggregates, and final water pressure difference of both ends of aggregates segment. The cementation form of grouted aggregates has four types; T shape, H shape, O shape and shell shape. The main mode of grout propagation includes three types; permeation filling mode, compaction- permeation mode, and compaction-fracturing mode, which reflects the influence of grain size, density of aggregates and grouting pressure. The variation of water pressure can be divided into four categories; overall ascending type, step ascending type, concave type, and convex type. The curve type mainly depends on water pressure, water flowrate, relative density and grain size of aggregates, gel time, propagation mechanism of grout. Conclusion The flow rate after grouting has decreased by approximately 60% to 86% compared to that before grouting, bulk hydraulic conductivity decreased by more than 80%, reflecting a great improvement of the sealing efficiency in the grouting stage after the pouring stage. The research on grout propagation in different graded aggregate mass has guiding significance for the design and construction of a rapid disaster treatment after groundwater inrush.

Grout Diffusion in Silty Fine Sand Stratum with High Groundwater Level for Tunnel Construction

Numerical Investigation of Grout Diffusion Accounting for the Dynamic Pressure Boundary Condition and Spatiotemporal Variation in Slurry Viscosity

Analytical Solutions of Steady a Seepage Field for Deep-Buried Tunnel with Grouting Ring Considering Anisotropic Flow

Experimental Study on Flow Water Diffusion of Cement-Sodium Silicate Grouting in Rough Fracture Model

Research on DOT Shield Tunnel Back-filled Synchronous Grouting Diffusion and Segments Circumferential Pressure Distribution

Diffusion Mechanism of Slurry during Grouting in a Fractured Aquifer: A Case Study in Chensilou Coal Mine, China

Advanced Grouting Model and Influencing Factors Analysis of Tunnels with High Stress and Broken Surrounding Rock

Grouting Mechanism in Water-Bearing Fractured Rock Based on Two-Phase Flow

A semi‐elliptical surface compound diffusion model for synchronous grouting filling stage in specially shaped shield tunnelling

Model Test on Segmental Grouting Diffusion Process in Muddy Fault of Tunnel Engineering

Effect of Grouting Reinforcement on Settlement of Existing Tunnels: Case Study of a New Crossing Underpass

Groundwater Inrush Control and Parameters Optimization of Curtain Grouting Reinforcement for the Jingzhai Tunnel

Micromechanism of the Diffusion of Cement-Based Grouts in Porous Media under Two Hydraulic Operating Conditions: Constant Flow Rate and Constant Pressure

Experimental Study on the Grouting Diffusion Process in Fractured Sandstone with Flowing Water Based on the Low-Field Nuclear Magnetic Resonance Technique

Research on Propagation Characteristics of Fracture Grouting in Clay Formation

Experimental study on the effect of water-cement ratios on the diffusion behavior of sand soil grouting

Study on the Influence of Back-fill Grouting Parameters in Unsaturated Strata on the Seismic Performance of Shield Tunnels

Research on slurry diffusion and seepage law in mining overburden fractures based on CFD numerical method

Lattice Boltzmann simulation for grout filling process during simultaneous backfill grouting of shield in tunnel construction

Experimental investigation on grout propagation in poured aggregates for controlling water inrush in tunnels with flowing water

Experimental Study on Fresh State Properties of Single-Liquid Semi-Inert Synchronous Grouting for Shield Tunnels in Water-Rich Sand Strata