Abstract:A comprehensive modeling framework for the thermoforming of polymer matrix woven laminate composite was developed. Two numerical indicators, the slip path length and traction magnitude, have been identified to be positively correlated to matrix smearing and wrinkling defects. The material model has been calibrated with picture-frame experimental results, and the prediction accuracy for intra-ply shear and thickness distribution was examined with measurements of the physically formed parts. Specifically, thickness prediction for most locations on the formed parts was accurate within an 11.6% error margin. However, at two points with significant intra-ply shear, the prediction errors increased to around 20%. Finally, a parametric study was conducted to determine the relationship between various process parameters and the quality of the formed part. For the trapezoidal part, orienting the laminate at 45 degrees to the mold axis reduces the likelihood of matrix smear and wrinkling defects. Although this laminate orientation yielded a greater spatial variation in part thickness, the thickness deviation is lower than that for the 0-degree orientation case. Two forming analyses were conducted with ramp rates of 25 mm/s and 80 mm/s to match the equipment's operational limits. It was observed that higher forming rates led to a greater likelihood of defects, as evidenced by a 15% and 10% increase in the formed part areas with longer slip paths and higher traction magnitudes, respectively. It was discovered that shallower molds benefit from faster ramp rates, while deeper molds require slower rates to manage extensive shearing, stretching and bending. Faster forming rates lead to smaller thickness increases at high intra-ply shear regions, indicating a shift from intra-ply shear to out-of-plane bending due to the visco-plastic effect of the molten laminate and can negatively impact part quality. Lastly, it was shown that a well-conceived strategy using darts could improve the part quality by reducing the magnitude of the defect indicators.

The Research on RTM Molding Process of Thin-wall Rib Structure of Composite Materials

Manufacture of thin composite structures by the RTM process: Numerical simulation of the shaping operation

Preparation of High-Performance Carbon Fiber-Reinforced Epoxy Composites by Compression Resin Transfer Molding

Process Simulation and Manufacture Testing of Composite Thick-Wall Drag Brace Via RTM Technology

Preparation and Validation of a Longitudinally and Transversely Stiffened Panel Based on Hybrid RTM Composite Materials

Development and application of resin transfer moulding (RTM) to aviation industry

Sheet Metal Forging Process for Thin-Walled Structures with Crossed Ribs: Process Design, Simulation and a Forming Experiment

Research Progress in Numerical Simulation of Fiber Reinforced Thermosetting Resin Matrix Composites Molding Process

Numerical Simulation of the Influence of Fibrous Structure on Resin Filling in RTM Process

Experimental and numerical study of thermoforming of Al/CFRP hybrid composites

Effect of processing method on the spring-in of aircraft ribs

Thermal Analysis of Cylindrical Molds Using Thermoplastic Composite During Robotic Fiber Placement

Prediction for the mechanical property of short fiber-reinforced polymer composites through process modeling method

A Modeling Framework for the Thermoforming of Carbon Fiber Reinforced Thermoplastic Composites

Effect of cold process drawing parameters on the formability and microstructure of ribbed cladding tubes

Multi-pass rolling-extrusion of large-scale thin-walled square tube with longitudinal inner ribs

Structure Design on Thermoplastic Composites Considering Forming Effects

Numerical Modelling of the Thermoforming Behaviour of Thermoplastic Honeycomb Composite Sandwich Laminates

Research on the Mechanism and Processability of Roll Forming

SIMULATION OF MOULD-FILLING IN RTM PROCESS FOR 3D COMPLEX SHAPE THIN SHELL PARTS

Study on the Ultrasonic-Assisted Spinning of Thin-Walled Cylindrical Parts with Longitudinal and Transverse Ribs