Abstract:About 10wt.% of glycerol can be produced during the conversion of vegetable oils or animal fats into biodiesel fuel by the transesterification process. To make use of glycerol and increase its values, H2 production from catalytic steam reforming of glycerol by Ni–Mg–Al based catalysts was evaluated experimentally in a fixed-bed reactor under atmospheric pressure within a temperature range of 450–650°C. The thermodynamic analysis was conducted by using a non-stoichiometric methodology based on the minimization of Gibbs free energy. The Ni–Mg–Al based catalysts were synthesized by the co-precipitation method with rising pH technique. The synthesized catalysts were characterized by the elemental analysis, BET, XRD and SEM methods. All the metals in the catalyst remained in oxide forms and the catalysts had the specific surface areas from 98.542 to 126.777m2/g for different compositions. The results showed that glycerol conversion and H2 selectivity were increased with increasing temperatures from 450 to 650°C. The formations of CH4 and CO in the glycerol steam reforming were almost negligible. Carbon formation in glycerol steam reforming was serious in low temperatures. The catalyst containing NiO of 24.1wt.%, MgO of 26.1wt.% and Al2O3 of 49.8wt.% performed appreciable catalytic activity, and the H2 selectivity was found to be 78.5% and conversion of glycerol was up to 88.0% at 650°C. The effects of the operating conditions including temperature, the ratio of steam to carbon (S/C), glycerol inlet concentration and flow rate of carrier gas on glycerol steam reforming by the optimized catalyst were tested. Based on a kinetic model assuming the power law with a first reaction order, the activation energy and the frequency factor for glycerol steam reforming by the Ni–Mg–Al based catalysts were calculated.

Hydrogen production from steam reforming of ethylene glycol over iron loaded on MgO

Hydrogen Production by Aqueous-Phase Reforming of Ethylene Glycol over Pt Catalysts Supported on Γ-Al2o3 Modified with Ce and Mg

Sorption-Enhanced Steam Reforming of Glycerol for Hydrogen Production over a NiO/NiAl2O4 Catalyst and Li2ZrO3-Based Sorbent

Hydrogen Production from Steam Reforming of Ethanol over Pd Promoted ZnO/Al2O3 Catalysts

ZnO-ZnFe2O4 Catalyst for Hydrogen Production from Methanol Steam Reforming

Hydrogen production from steam reforming of glycerol by Ni–Mg–Al based catalysts in a fixed-bed reactor

Hydrogen Production from the Water-Gas Shift Reaction on Iron Oxide Catalysts

Hydrogen production by steam reforming of ethanol over flowerlike micro spheres NiO/CeO 2 catalyst

Renewable hydrogen production from steam reforming of glycerol by Ni–Cu–Al, Ni–Cu–Mg, Ni–Mg catalysts

Aqueous-Phase Reforming of Ethylene Glycol to Hydrogen on Supported Pt Catalysts

Hydrogen Production from Steam Reforming of Hydrocarbons over Alkaline-Earth Metal-Modified Fe- or Ni-Based Catalysts

Catalytic steam reforming of dimethyl ether for hydrogen production

Hydrogen Production by Catalytic Steam Reforming of Heavy Components in Bio-Oil in Fluidized Bed Reactor

Hydrogen Production by Catalytic Steam Reforming of Model Compounds of Bio-Oil

Catalytic Conversion Of Bio-Oil To Hydrogen On The C12a7-Mgo Catalyst

Hydrogen Production from Methanol Steam Reforming over Fe-Modified Cu/CeO2 Catalysts

Ni Supported on MgO Modified Attapulgite As Catalysts for Hydrogen Production from Glycerol Steam Reforming

Carbon Monoxide-Free Hydrogen Production Via Low-Temperature Steam Reforming of Ethanol over Iron-Promoted Rh Catalyst

Synergy Effect of MgO and ZnO in a Ni/Mg–Zn–Al Catalyst During Ethanol Steam Reforming for H2-rich Gas Production

Hydrogen production from glycerol steam reforming over Ni/La/Co/Al2O3 catalyst

Renewable Hydrogen Production from Steam Reforming of Glycerol (SRG) over Ceria-Modified Γ-Alumina Supported Ni Catalyst