Hydrogen Production by Aqueous-Phase Reforming of Ethylene Glycol over Pt Catalysts Supported on Γ-Al2o3 Modified with Ce and Mg

Y Bai,CS Lu,L Ma,P Chen,YF Zheng,XN Li
DOI: https://doi.org/10.3321/j.issn:0253-9837.2006.03.017
IF: 16.5
2006-01-01
Chinese Journal of Catalysis
Abstract:Pt catalysts supported on gamma-Al2O3 modified with Ce or Mg were prepared by Impregnation with a H2PtCl6 aqueous solution and used in the hydrogen production by aqueous-phase reforming of ethylene glycol. Catalytic activity testing, N-2 physical, adsorption, CO chemical adsorption, X-ray diffraction (XRD), and temperature- programmed reduction (TPR) were employed to evaluate the activity, hydrogen selectivity, and physicochemical properties of the catalysts. The results indicate that Pt catalysts supported on gamma-Al2O3 modified with Ce or Mg show higher activity than the Pt/gamma-Al2O3 catalyst. At the temperature of 498 K and pressure of 2.58 MPa, the conversion of ethylene glycol is increased from 72.3% over Pt/gamma-Al2O3 to 100% over Pt/(Ce) gamma-Al2O3 or Pt/(Mg)gamma-Al2O3, and the selectivity for hydrogen almost reaches 100%. The characteristic peaks attributed to CeO2, Mg-Al layer chemical component, and Mg-Al spinel have been observed besides the gamma-Al2O3 peak in the XRD patterns of Pt/(Ce)gamma-Al2O3 and Pt/(Mg)gamma-Al2O3. The presence of Cc not only increases the dispersion of Pt on the surface of gamma-Al2O3, but also improves the adsorption- cracking of ethylene glycol on Pt and water-gas shift reaction; while the presence of Mg neutralizes the acidity of gamma-Al2O3, influences the dispersion of PtCl62-, and inhibits the dehydration of ethylene glycol.
What problem does this paper attempt to address?