Hydrogen production from aqueous phase reforming of glycerol over attapulgite-supported nickel catalysts: Effect of acid/base treatment and Fe additive
Wen Cheng,Yishuang Wang,Mingqiang Chen,Defang Liang,Chang Li,Zhonglian Yang,Jun Wang
DOI: https://doi.org/10.1016/j.ijhydene.2021.12.082
IF: 7.2
2022-02-01
International Journal of Hydrogen Energy
Abstract:In this paper, a series of nickel-based catalysts supported on modified attapulgite (ATP) by acid (citric acid and EDTA) and base (NaOH) were prepared and applied to the aqueous phase reforming of glycerol (APRG). The modified ATP (MA) and as-prepared catalysts were detected using N2 adsorption-desorption, ICP-OES, XRD, FT-IR, SEM-EDS, HRTEM, XPS, H2-TPR, NH3-TPD. The results manifested that the acid/base treatment of ATP significantly increased the surface area and pore volume, enhanced the metal-support interaction (MSI) and decreased the Ni particle size, resulting in the better glycerol conversion and H2 selectivity, especially for Ni/MA-E catalyst, where the ATP was pretreated using EDTA. In addition, the bimetallic NiFe/MA-E catalyst exhibited the highest conversion of glycerol to gas product (54.4%) and H2 selectivity (84.6%) at very low temperature (280 °C). These results were attributed to the strongest the interplay of active metal with support by the formation of Ni–Fe alloy, resulting in the highest active metal dispersion, smallest metal particle size, lowest the reducibility of active metal and most surface Ni0 content. According to the characterizations of spent catalysts, it demonstrated that monometallic Ni catalysts presented obvious sintering of Ni metal particle and larger accumulation of carbon deposition, which led to the deactivation of the catalyst. While NiFe/MA-E catalyst showed less particle agglomeration and coke formation attributed to the lower content of surface acid site. Apart from that, another cause of catalyst deactivation might be the destruction of ATP skeleton during APRG.
energy & fuels,electrochemistry,chemistry, physical