Abstract:Randomness in the void distribution within a ductile metal complicates quantitative modeling of damage following the void growth to coalescence failure process. Though the sequence of micro-mechanisms leading to ductile failure is known from unit cell models, often based on assumptions of a regular distribution of voids, the effect of randomness remains a challenge. In the present work, mesoscale unit cell models, each containing an ensemble of four voids of equal size that are randomly distributed, are used to find statistical effects on the yield surface of the homogenized material. A yield locus is found based on a mean yield surface and a standard deviation of yield points obtained from 15 realizations of the four-void unit cells. It is found that the classical GTN model very closely agrees with the mean of the yield points extracted from the unit cell calculations with random void distributions, while the standard deviation $\textbf{S}$ varies with the imposed stress state. It is shown that the standard deviation is nearly zero for stress triaxialities $T\leq1/3$, while it rapidly increases for triaxialities above $T\approx 1$, reaching maximum values of about $\textbf{S}/\sigma_0\approx0.1$ at $T \approx 4$. At even higher triaxialities it decreases slightly. The results indicate that the dependence of the standard deviation on the stress state follows from variations in the deformation mechanism since a well-correlated variation is found for the volume fraction of the unit cell that deforms plastically at yield. Thus, the random void distribution activates different complex localization mechanisms at high stress triaxialities that differ from the ligament thinning mechanism forming the basis for the classical GTN model. A method for introducing the effect of randomness into the GTN continuum model is presented, and an excellent comparison to the unit cell yield locus is achieved.

Experimental determination of the void volume fraction for S235JR steel at failure in the range of high stress triaxialities

Experimental Evaluation of Microvoid Characteristics and Relationship with Stress and Strain for Ductile Fracture

Anisotropic Gurson-Tvergaard-Needleman model considering the anisotropic void behaviors

Extended GTN Model for Predicting Ductile Fracture under a Broad Range of Stress States

Effect of stress triaxiality on micro-mechanisms of void coalesence and micro-fracture ductility of materials

A Ductile Fracture Criterion Based on Three-Dimensional Void Model

A New Ductile Fracture Criterion for Various Deformation Conditions Based on Microvoid Model

Modified Gtn Model for A Broad Range of Stress States and Application to Ductile Fracture

THE CRITERION OF CRITICAL VOID GROWTH RATE AND ITS APPLICATIONS

Experimental and FE analysis of void closure in hot rolling of stainless steel

An Independent Derivation and Verification of the Voids Nucleation Failure Mechanism: Significance for Materials Failure

A micro-mechanics based extension of the GTN continuum model accounting for random void distributions

Analysis of Metallic Ductile Fracture by extended Gurson models

Ductile Damage Analysis for Small Punch Specimens of Type 304 Stainless Steel Based on GTN Model

Use of a modified Gurson model for the failure behaviour of the clinched joint on Al6061 sheet

Tension–torsion fracture experiments – Part II: Simulations with the extended Gurson model and a ductile fracture criterion based on plastic strain

A New Void Coalescence Mechanism During Incremental Sheet Forming: Ductile Fracture Modeling and Experimental Validation

Stress Triaxiality in Anisotropic Metal Sheets—Definition and Experimental Acquisition for Numerical Damage Prediction

Investigation of ductile damage in dual phase steel during tensile deformation by in situ X-ray computed tomography

In-situ Three-dimensional Investigation on Micro Ductile Fracture Mechanism of Mild Steel

A void descriptor function to uniquely characterize pore networks and predict ductile-metal failure properties