Abstract:The lithographically tunable and small size features of Lamb wave resonators (LWRs) take a bright future for their use in high frequency narrow band filters. Resonant frequency drift due to temperature variation has a large impact on the narrower passband and a temperature coefficient of frequency (TCF) closer to 0 can broaden the stable temperature range of the resonator. This paper proposes a method of etching grooves in the area of the piezoelectric layer not covered by the Interdigital transducer (IDT) electrodes to improve the temperature stability of the Lamb resonator. Through the finite element method and theoretical analysis, the phase velocity, group velocity, and TCF dispersion curve of different modes of the resonator with groove structure were determined. The reason for the change of TCF under different normalized thicknesses of AlN was explained through the conversion of the LWR from a contour mode resonator (CMR) to a Cross-Sectional Lamé Mode Resonator. Simulation and test have shown that etching grooves have the effect of reducing TCF by adjusting the electromechanical coupling coefficient. The test shows that 205 nm-depth grooves can lower the TCF of the S0 mode IDT-Open LWR from −13.3 to −5.1 ppm/°C and S1 mode from −36.8 to −9.0 ppm/°C, respectively. The TCF of S0 and S1 mode LWRs decreased by 61.7% and 75.5%, respectively, after 205 nm groove etching. The groove etching method greatly raises the temperature stability of the LWR, enabling Lamb wave filters to operate stably over a wider temperature range.

AlN/ScAlN composite films-based spurious free A1 mode lamb wave resonator with adjustable effective electromechanical coupling coefficient

Adjustable effective electromechanical coupling of Lamb wave resonator using AlN/Sc0.096Al0.904N composite films

AlN/Al0.8Sc0.2N film S0 mode lamb wave resonator with spurious mode suppression

Spurious-Free S1 Mode AlN/ScAlN-Based Lamb Wave Resonator With Trapezoidal Electrodes

High Electromechanical Coupling Factor Lamb Wave Resonator

Transducer design for AlN Lamb wave resonators

High Figure-of-Merit A1-Mode Lamb Wave Resonators Operating Around 6 GHz Based on the LiNbO3 Thin Film

High speed surface acoustic wave and laterally excited bulk wave resonator based on single-crystal non-polar AlN film

Preparation, Characterization, and Application of AlN/ScAlN Composite Thin Films

6 GHz lamb wave acoustic filters based on A1-mode lithium niobate thin film resonators with checker-shaped electrodes

Analysis and Suppression of Spurious In-Plane Lamé-Like Modes in Lamb Wave Resonators

High Electromechanical Coupling SAW Resonators Based on a-Plane AlScN-AlN-Sapphire Substrate

Aln Checker-Mode Resonators With Routing Structures

Ultra flexible pseudo-lamb wave RF resonators based on ZnO/PI and AlN/PI structures

Low temperature coefficient of frequency AlN Lamb wave resonator using groove structure between interdigital transducers

Study on the impact of the resonant cavity and lateral acoustic edge reflector for AlSc 0.095 N-based S0 mode Lamb-wave resonators

AlScN-Based Dual-Mode Devices With Temperature Compensated Strategy and Process Optimization

Design of high-frequency surface acoustic wave resonators based on Al0.8Sc0.2N/AlN/Sapphire multilayer structure

High-Performance N79 Band AlScN BAW Resonator and Filter with the Consideration of Area Effect

Aluminum scandium nitride thin-film bulk acoustic resonators for 5G wideband applications

LITHIUM NIOBATE THIN FILM BASED A1 MODE RESONATORS WITH FREQUENCY UP TO 16 GHZ AND ELECTROMECHANICAL COUPLING FACTOR NEAR 35%