Abstract:Ceramics from porous Si3N4 and its derivatives SiAlON and Si2N2O were once considered the most promising high-temperature wave-transmitting materials. However, their large-scale application in the field of radomes is greatly restricted due to their poor oxidation resistance, high preparation costs, and expensive raw materials. Therefore, the development of low-cost porous oxide ceramics remains of significant interest to the field of high-temperature wave transmission. Surprisingly, mullite ceramics, which are representative of the Al2O3-SiO2-system of ceramics, are ultra-low-cost materials with the potential to replace ceramics from Si3N4 and its derivatives. In this paper, integrated porous Al2O3-SiO2-system ceramics were successfully prepared for load-bearing/wave-transmitting applications, using inexpensive calcined kaolin and alumina powder as the main raw materials. Calcined kaolin can provide seeds for the growth and development of mullite crystals in the ceramic system. High-strength and high-porosity ceramics were obtained with the mullite morphology controlled through the molar ratio of Al2O3 to SiO2 and the resulting content of mullite seeds. With increasing of mullite seed content, the length and radial width of mullite whiskers with "interlocking structure" gradually change from rod-shaped "long and thick" to needle-like "short and thin." The prepared porous Al2O3-SiO2 ceramics have high flexural strength, fracture toughness, and good dielectric properties.

A comparative study on dielectric and mechanical properties of porous β-Si3N4 ceramics by controlling porosity and microstructure

Numerical and Experimental Studies of the Pore Size Impacts on Dielectric and Mechanical Properties for Porous Si <sub>3</sub>N <sub>4</sub> for Radome Application

Optimization of Microstructure to Improve Si3n4 Ceramics with Thermal Conductivity and Mechanical Properties: Effect of Si and Α-Si3n4 Powder Composition

The lamellar preparation of continuous porosity-graded Si3N4 ceramics without obvious interfaces for broadband radome application

Mechanical and Dielectric Properties of Porous Si3N4–SiC(BN) Ceramic

Microstructure, Mechanical and Dielectric Properties of Highly Porous Silicon Nitride Ceramics Produced by a New Water-Based Freeze Casting

Mechanical and Dielectric Properties of Porous Si3n4-Sio2 Composite Ceramics

Dielectric and mechanical properties of porous Si 3N 4-BN ceramic composites

Study on Microstructure and Mechanical Properties of Porous Si<sub>3</sub>N<sub>4</sub> Ceramics

Porous Si3N4-based Ceramics with Uniform Pore Structure Originated from Single-Shell Hollow Microspheres

Study on microstructure and mechanical properties of porous Si3N4 ceramics

Increased microwave absorption property of porous Si3N4 ceramics by loading polymer-derived SiCN for a multifunctional design

High Performance Porous Wave-Transmitting Silicon Nitride Ceramics by Gel-Casting Technique

Tuning the dielectric properties of porous BN/Si3N4 composites by controlling porosity

Effects of pore structures on the dielectric properties of silicon nitride-based ceramics

Effect Of Porosity On Mechanical And Dielectric Properties Of 20%Bn/Si3n4 Composite Porous Ceramics

Sintering behavior and morphology control of porous Al2O3-SiO2 ceramics for radome applications

In-situ Reaction Synthesis of Porous Si2N2O-Si3N4 Multiphase Ceramics with Low Dielectric Constant Via Silica Poly-Hollow Microspheres

Mechanical and dielectric properties of porous Si3N4 ceramics prepared by modified water‐based gel casting

Comparison in Microstructure and Mechanical Properties of Porous Si3n4 Ceramics with Sic and Si3n4 Coatings

Dielectric and Mechanical Properties of Porous Si3N4-BN Ceramic Composites