Abstract:Most of the previous literature on fluidized bed agglomeration during biomass combustion is based on quartz as a bed material. Full-scale installations however often use natural sand, which apart from quartz may contain a high fraction of non-quartz minerals such as potassium feldspar and plagioclase. The objective of the present study was therefore to elucidate the effects of non-quartz minerals occurring in natural sand on the agglomeration behavior during fluidized bed combustion of biomass fuels. Three fuels typical for previously determined agglomeration mechanisms were chosen as model fuels: calcium-rich bark, potassium-rich olive residues, and silica- and potassium-rich wheat straw. Two different feldspar minerals were used: a potassium feldspar and a plagioclase, labradorite, which both occur in many commercial bed materials. Furthermore, olivine was used as a bed material as this mineral represents another type of bed material used in some full-scale installations. Quartz was used as a reference bed material. The effects of non-quartz minerals in natural sand on initial defluidization temperature were assessed during carefully controlled, bench-scale fluidized bed agglomeration experiments. Bed material samples and agglomerates were analyzed using scanning electron microscopy/energy-dispersive spectroscopy (SEM/EDS) in order to explore the occurrence and chemical composition of coating and attack layers on the bed particles and necks between agglomerated particles. Significant differences in agglomeration characteristics were found for the different minerals when bark and olive residue were combusted. Potassium-feldspar was shown to lower the initial defluidization temperature for combustion of bark and olive residues. Plagioclase and olivine on the other hand were found to increase the initial defluidization temperature as compared to quartz for the combustion of olive residue, but for bark combustion, they did not differ significantly from quartz. During combustion of wheat straw, all bed materials agglomerated shortly after the startup of the experiment. For bark and olive residue samples, attack layers were found on all bed materials and the composition of the inner attack layer and agglomerate necks differed significantly with the fuel/bed material combination. For wheat straw however, no continuous attack layers were found, and the bed material composition was concluded not to influence the agglomeration characteristics for this biomass. The results were used to suggest possible mechanisms involved in layer formation for the different minerals.

An experimental investigation into the effect of sodium salts on quartz particle agglomeration and bed defluidisation in a bubbling fluidised bed

Stable Operating Range and Solids Residence Time of Fine Fluorite Particles in the Two-Stage Fluidized Bed

Research on Separation Mechanism of Liquid-Solid Fluidized Bed Separator

Experimental Investigation of Electrostatic Effect on Particle Motions in Gas-Solid Fluidized Beds

Experimental and Modeling Investigation of Liquid-Induced Agglomeration in a Gas–Solid Fluidized Bed with Liquid Spray

AGGLOMERATION BEHAVIOR IN A BUBBLING FLUIDIZED BED AT HIGH TEMPERATURE

Kinetic Study on Crystal Growth of NaCl and K2SO4

An experimental investigation into bed particle agglomeration and ash deposition during circulating fluidized bed gasification of Zhundong lignite

Flow Characteristics and Defluidization Behavior with Agglomeration at High Temperature Fluidized Bed

An experimental investigation into the effect of flue gas recirculation on ash deposition and Na migration behaviour in circulating fluidized bed during combustion of high sodium Zhundong lignite

Experimental Study of Alkali Salt Adsorption in a Circulating Fluidized Bed Boiler

Effects of Interparticle Forces on Fluidization Characteristics in Liquid-Containing and High-Temperature Fluidized Beds

Effects of Superheated Surface on the Deposition Behavior of Na2SO4 in Supercritical Water

Effects of Non-Quartz Minerals in Natural Bed Sand on Agglomeration Characteristics during Fluidized Bed Combustion of Biomass Fuels

Heat transfer performance of a vapor–liquid–solid three-phase circulating fluidized bed evaporation system with different concentrations of Na2SO4 solutions

The Effect of Inorganic Salt on Multiphase Flow Characteristics in a Microbubble Column: A Focus on the Ionic Strength

Numerical Investigation on Deposition Rate of Mechanically Mixed Ash Particles in an Entrained Flow Reactor

Mechanisms and characteristics of ash layer formation on bed particles during circulating fluidized bed combustion of Zhundong lignite

Thermal Stress-Induced Fragmentation of Quartzite Particles in a Hot Fluidized Bed

Attrition experiment and gray relational analysis of quartzite particles as medium material in fluidized bed

Numerical and Experimental Investigation of the Effects of Impinging Streams to Enhance Ca-based Sorbent Capture of SO2