Abstract:Fluidized beds reactors with liquid bridge and solid bridge coupling actions have been widely used in industry and thus studies of particle agglomerations under such fluidization conditions are of great significance. This work proposed an experimental apparatus combining electro-magnetic induction heating system with fluidized bed to simulate the real conditions for particle reaction heat release and heat transfer in industrial polymerization fluidized bed reactors. The effects of liquid content on agglomeration behavior of wax/graphite composite particles under different fluidization gas temperatures, gas velocities and heating powers have been studied. Through a force balance analysis of particles with liquid bridge and solid bridge coupling actions, relative solid bridge force was taken as a key parameter to demonstrate the effects of solid bridge force and other forces on agglomerations. Results showed that as the relative solid bridge force varied in different ranges, the agglomeration mass presented three different variation trends with liquid increases, namely monotonic increasing, non-monotonic changing and monotonic decreasing, due to different dominating agglomerating mechanisms (liquid evaporation and liquid bridge) during fluidization. According to the results of this study, the proposed criterion based on relative solid bridge force can be used to guide the regulation and control of particle agglomerations in fluidization with liquid bridge and solid bridge coupling actions.

Flow Characteristics and Defluidization Behavior with Agglomeration at High Temperature Fluidized Bed

AGGLOMERATION BEHAVIOR IN A BUBBLING FLUIDIZED BED AT HIGH TEMPERATURE

Particle Fluidization Characteristics and Transition in a Hot Gas-Solid Fluidized Bed with Liquid Injection

Effect of Agitation on the Fluidization Behavior of a Gas–solid Fluidized Bed with a Frame Impeller

Investigating Agglomeration Behaviors in High Temperature Gas–Solid Fluidized Beds with Liquid Injection

Modeling Agglomeration Behavior in High Temperature Gas–Solid Fluidized Beds Via Monte Carlo Method

Characterization of Flow Pattern of Cohesive Particles in Gas-Solid Fluidized Bed Via Axial Distribution of Particle Motions

Fluidization of Cohesive Fluorite Particles at Ambient/High Temperatures and Enhancement Methods

Effects of Interparticle Forces on Fluidization Characteristics in Liquid-Containing and High-Temperature Fluidized Beds

Experimental Investigation of Bubble and Particle Motion Behaviors in A Gas-Solid Fluidized Bed with Side Wall Liquid Spray

Experimental and Modeling Investigation of Liquid-Induced Agglomeration in a Gas–Solid Fluidized Bed with Liquid Spray

Flow characteristics in a bubbling fluidized bed at elevated temperature

Minimum fluidization velocity of bimodal polyethylene particles

Stable Operating Range and Solids Residence Time of Fine Fluorite Particles in the Two-Stage Fluidized Bed

Particle Agglomeration and Control of Gas-Solid Fluidized Bed Reactor with Liquid Bridge and Solid Bridge Coupling Actions

Fluidization Behavior of a High-temperature Bubbling Fluidized Bed

A Numerical Investigation on Segregation in Gas-Fluidized Beds of Short, Flexible Fibers

Inhomogeneous temperature in high temperature fluidized beds

An experimental investigation into the effect of sodium salts on quartz particle agglomeration and bed defluidisation in a bubbling fluidised bed

Hydrodynamics of Bubbling Fluidized Beds at High Temperature

A Numerical Study on Gas-Fluidized Beds of Wet Flexible Fibers