Abstract:A discrete element method (DEM) model is developed to simulate the dynamics of wet, flexible fibers. The angles of repose of dry and wet fibers are simulated, and the simulation results are in good agreement with experimental results, validating the wet, flexible fiber model. To study wet fiber flow behavior, the model is used to simulate shear flows of wet fibers in a periodic domain under Lees-Edwards boundary conditions. Significant agglomeration is observed in dilute shear flows of wet fibers. The size of the largest agglomerate in the flow is found to depend on a Bond number, which is proportional to liquid surface tension and inversely proportional to the square of the shear strain rate. This Bond number reflects the relative importance of the liquid-bridge force to the particle's inertial force, with a larger Bond number leading to a larger agglomerate. As the fiber aspect ratio (AR) increases, the size of the largest agglomerate increases, while the coordination number in the largest agglomerate initially decreases and then increases when the AR is greater than four. A larger agglomerate with a larger coordination number is more likely to form for more flexible fibers with a smaller bond elastic modulus due to better connectivity between the more flexible fibers. Liquid viscous force resists pulling of liquid bridges and separation of contacting fibers, and therefore it facilitates larger agglomerate formation. The effect of liquid viscous force is more significant at larger shear strain rates. The solid-phase shear stress is increased due to the presence of liquid bridges in moderately dense flows. As the solid volume fraction increases, the effect of fiber-fiber friction coefficient increases sharply. When the solid volume fraction approaches the maximum packing density, the fiber-fiber friction coefficient can be a more dominant factor than the liquid bridge force in determining the solid-phase shear stress.

A Numerical Study on Gas-Fluidized Beds of Wet Flexible Fibers

Discrete element method-computational fluid dynamics analyses of flexible fibre fluidization

CFD Simulation of an Agitated Gas-Fluidized Bed: Effects of Particle–particle Restitution Coefficient on the Hydrodynamics

Experimental and numerical investigation of solid behavior in a gas–solid turbulent fluidized bed

Research Progress in Numerical Models on Gas-Solid Fluidization of Cohesive Particles

Numerical simulation of pressure fluctuation in gas-solids agitated fluidized bed

Experimental and Modeling Investigation of Liquid-Induced Agglomeration in a Gas–Solid Fluidized Bed with Liquid Spray

Evolution and Fluidization Behaviors of Wet Agglomerates Based on Formation-Fragmentation Competition Mechanism

CFD Simulation and Experiments of Dynamic Parameters in Gas–solid Fluidized Bed

A Numerical Investigation on Segregation in Gas-Fluidized Beds of Short, Flexible Fibers

Particle Agglomeration and Control of Gas-Solid Fluidized Bed Reactor with Liquid Bridge and Solid Bridge Coupling Actions

Particle Fluidization Characteristics and Transition in a Hot Gas-Solid Fluidized Bed with Liquid Injection

Experimental Investigation of Bubble and Particle Motion Behaviors in A Gas-Solid Fluidized Bed with Side Wall Liquid Spray

Dynamic Modelling of Fluidisation in Gas-Solid Bubbling Fluidised Beds

Effects of Interparticle Forces on Fluidization Characteristics in Liquid-Containing and High-Temperature Fluidized Beds

Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers.

Study on a Semi-Resolved CFD-DEM Method for Rod-Like Particles in a Gas-Solid Fluidized Bed

CFD-DEM Investigation of the Fluidization of Binary Mixtures Containing Rod-Like Particles and Spherical Particles in a Fluidized Bed

Clustering in Gas-Fluidized Riser Flows of Flexible Fibers

Numerical Study of Particle Injection into a Gas-Solid Fluidized Bed

Particle-scale Simulation of Fluidized Bed with Immersed Tubes