Abstract:A discrete element method (DEM) model is developed to simulate the dynamics of wet, flexible fibers. The angles of repose of dry and wet fibers are simulated, and the simulation results are in good agreement with experimental results, validating the wet, flexible fiber model. To study wet fiber flow behavior, the model is used to simulate shear flows of wet fibers in a periodic domain under Lees-Edwards boundary conditions. Significant agglomeration is observed in dilute shear flows of wet fibers. The size of the largest agglomerate in the flow is found to depend on a Bond number, which is proportional to liquid surface tension and inversely proportional to the square of the shear strain rate. This Bond number reflects the relative importance of the liquid-bridge force to the particle's inertial force, with a larger Bond number leading to a larger agglomerate. As the fiber aspect ratio (AR) increases, the size of the largest agglomerate increases, while the coordination number in the largest agglomerate initially decreases and then increases when the AR is greater than four. A larger agglomerate with a larger coordination number is more likely to form for more flexible fibers with a smaller bond elastic modulus due to better connectivity between the more flexible fibers. Liquid viscous force resists pulling of liquid bridges and separation of contacting fibers, and therefore it facilitates larger agglomerate formation. The effect of liquid viscous force is more significant at larger shear strain rates. The solid-phase shear stress is increased due to the presence of liquid bridges in moderately dense flows. As the solid volume fraction increases, the effect of fiber-fiber friction coefficient increases sharply. When the solid volume fraction approaches the maximum packing density, the fiber-fiber friction coefficient can be a more dominant factor than the liquid bridge force in determining the solid-phase shear stress.

Clustering in Gas-Fluidized Riser Flows of Flexible Fibers

CFD-DEM Simulation of Clustering Phenomena in Riser and Downer

Discrete element method-computational fluid dynamics analyses of flexible fibre fluidization

A Numerical Study on Gas-Fluidized Beds of Wet Flexible Fibers

Eulerian-Lagrangian Simulation of Distinct Clustering Phenomena and Rtds in Riser and Downer

A Numerical Investigation on Segregation in Gas-Fluidized Beds of Short, Flexible Fibers

Multi-scale Characteristics and Gas-Solid Interaction among Multiple Beds in a Dual Circulating Fluidized Bed Reactor System

A CFD–DEM study of the cluster behavior in riser and downer reactors

Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers.

Computational Characterisation of Intermittent Hydrodynamic Behaviours in a Riser with Geldart A Particles

Coupling particle image velocimetry and digital image analysis to characterize cluster dynamics in a fast fluidized bed

Cluster Behavior In Cfb Riser And Downer Simulated By Cfd-Dpm Method

Investigation of cluster property in the riser of circulating fluidized bed with a wide particle size distribution

On Coherent Structures in Gas–solid Fluidization

FLOW BEHAVIOR OF DENSE CLUSTERS IN RISER

Computational Fluid Dynamics–Discrete Element Method (CFD-DEM) Study of Mass-Transfer Mechanisms in Riser Flow

Clusters intermittent simulations using dynamic cluster structure-dependent drag model in gas-particles risers

Breakage of Wet Flexible Fiber Agglomerates Impacting a Plane

A dynamic cluster structure-dependent drag coefficient model applied to the riser in high density circulating fluidized bed

Impact of polydispersity on the flow dynamics in the riser of a circulating fluidized bed

Particle‐level dynamics of clusters: Experiments in a gas‐fluidized bed